Hi
I need the write up for the code used in generating a graph of the compression ratio of a Otto engine to its efficiency. I don't have any idea on how to write the code. thanks ....etc

[:=Read Full Message Here=:]

The Kalina cycle is a thermodynamic cycle for converting thermal energy to mechanical power which utilizes working fluid comprised of at least two different components and a ratio between those components is varied in different parts of the system to increase thermodynamical reversibility and therefore increase overall thermodynamic efficiency. There are multiple variants of Kalina cycle systems specifically applicable for different types of heat sources. Several proof of concept power plants using the kalina have already been built.

The Kal ....etc

[:=Read Full Message Here=:]

The Lenoir cycle is an idealised thermodynamic cycle for the pulse jet engine. An ideal gas undergoes

1. constant volume heating
2. reversible adiabatic expansion.
3. isobaric compression to the volume at the start of the cycle.

The expansion process is isentropic and hence involves no heat interaction. Energy is absorbed as heat during the constant volume process and rejected as heat during the constant pressure process. ....etc

[:=Read Full Message Here=:]

The Scuderi Split Cycle Engine design is a rethink of the conventional four-stroke Otto cycle internal combustion engine conceived by Carmelo J. Scuderi (1925-2002). While as of this writing no working prototype of the engine exists, computer simulations carried out by the Scuderi Group and the Southwest Research Institute showed promising gains in efficiency and toxic emissions. It also has the innate capacity to power an air hybrid system.

n a conventional Otto-cycle engine, each cylinder performs four strokes per cycle: intake, compressi ....etc

[:=Read Full Message Here=:]

The Atkinson cycle engine is a type of Internal combustion engine invented by James Atkinson in 1882. The Atkinson cycle is designed to provide efficiency at the expense of power.

The Atkinson cycle allows the intake, compression, power, and exhaust strokes of the four-stroke cycle to occur in a single turn of the crankshaft. Owing to the linkage, the expansion ratio is greater than the compression ratio, leading to greater efficiency than with engines using the alternative Otto cycle.

The Atkinson cycle may also refer to a four stroke en ....etc

[:=Read Full Message Here=:]

i want matlab simulation of one cycle control for of buck converter , i also want the same for boost, cuk converter. and research level simulation and thesis which lead to m.tech desertation. ....etc

[:=Read Full Message Here=:]

IDEAL INSTITUTE OF TECHNLOGY, GHAZIABAD


INTRODUCTION


-NTPC is the largest power company of India and was set up in 1975. It is among the world’s largest and most efficient power generation companies.

-NTPC has installed capacity of 29,394 MW. It has 15 coal based(23,395 MW) and 7 gas based power stations(3955 MW) and 4 joint ventures(1794 MW).

-NTPC’s share in the total installed capacity of the country is 19.1% and it has contributed 28.50% of the total power generation of the country.

-Governme ....etc

[:=Read Full Message Here=:]

Preface:
Power generation is an important issue today, especially on the West Coast. Demand is outweighing supply because of lack of incentives for the utilities industry to build additional power plants over the past 10-20 years. Electrical innovations (such as the personal computer) were not accounted for in earlier predictions of power utilization and, now, the country is in dire need of streamlining the current power plants while pushing through as many applications as possible for new power plants. In response to this situation, ....etc

[:=Read Full Message Here=:]

Introduction

The Atkinson cycle engine is a type of Internal combustion engine invented by James Atkinson in 1882. The Atkinson cycle is designed to provide efficiency at the expense of power.

The Atkinson cycle allows the intake, compression, power, and exhaust strokes of the four-stroke cycle to occur in a single turn of the crankshaft. Owing to the linkage, the expansion ratio is greater than the compression ratio, leading to greater efficiency than with engines using the alternative Otto cycle.

The Atkinson cycle may also ....etc

[:=Read Full Message Here=:]

If the secondary coil is attached to a load that allows current to flow, electrical power is transmitted from the primary circuit to the secondary circuit.Ideally,the transformer is perfectly efficient; all the incoming energy is transformed from the primary circuit to the magnetic field and into the secondary circuit. If this condition is met, the incoming electric power must equal the outgoing power.
Pincoming = IPVP = Poutgoing = ISVS

giving the ideal transformer equation

....etc

[:=Read Full Message Here=:]