The Scuderi Split Cycle Engine design is a rethink of the conventional four-stroke Otto cycle internal combustion engine conceived by Carmelo J. Scuderi (1925-2002). While as of this writing no working prototype of the engine exists, computer simulations carried out by the Scuderi Group and the Southwest Research Institute showed promising gains in efficiency and toxic emissions. It also has the innate capacity to power an air hybrid system.

n a conventional Otto-cycle engine, each cylinder performs four strokes per cycle: intake, compressi ....etc

[:=Read Full Message Here=:]

The Atkinson cycle engine is a type of Internal combustion engine invented by James Atkinson in 1882. The Atkinson cycle is designed to provide efficiency at the expense of power.

The Atkinson cycle allows the intake, compression, power, and exhaust strokes of the four-stroke cycle to occur in a single turn of the crankshaft. Owing to the linkage, the expansion ratio is greater than the compression ratio, leading to greater efficiency than with engines using the alternative Otto cycle.

The Atkinson cycle may also refer to a four stroke en ....etc

[:=Read Full Message Here=:]

sir plz an u send code for flying butterfly...and movement of trains in opposite direction with traffic signal..plz its vry urgent... ....etc

[:=Read Full Message Here=:]

i want matlab simulation of one cycle control for of buck converter , i also want the same for boost, cuk converter. and research level simulation and thesis which lead to m.tech desertation. ....etc

[:=Read Full Message Here=:]

Preface:
Power generation is an important issue today, especially on the West Coast. Demand is outweighing supply because of lack of incentives for the utilities industry to build additional power plants over the past 10-20 years. Electrical innovations (such as the personal computer) were not accounted for in earlier predictions of power utilization and, now, the country is in dire need of streamlining the current power plants while pushing through as many applications as possible for new power plants. In response to this situation, ....etc

[:=Read Full Message Here=:]

Hi I need source code of butterfly in opengl and report ....etc

[:=Read Full Message Here=:]

Introduction

The Atkinson cycle engine is a type of Internal combustion engine invented by James Atkinson in 1882. The Atkinson cycle is designed to provide efficiency at the expense of power.

The Atkinson cycle allows the intake, compression, power, and exhaust strokes of the four-stroke cycle to occur in a single turn of the crankshaft. Owing to the linkage, the expansion ratio is greater than the compression ratio, leading to greater efficiency than with engines using the alternative Otto cycle.

The Atkinson cycle may also ....etc

[:=Read Full Message Here=:]

please send the source code for the lifecycle of a butterfly immediately which is done using opengl to [email protected] ....etc

[:=Read Full Message Here=:]

OTTO CYCLE



INTRODUCTION

The Otto cycle is the air standard cycle of the SI engine.


It is named after Nikolaus A. Otto, a German engineer, who first built a successful four-stroke SI engine in 1876 by using the cycle proposed by Frenchman Alphouse Beau Richas in 1862.


AIR STANDARD CYCLE

A thermodynamic cycle in which the working fluid is considered to be a perfect gas.

The engine utilize a gas as the working fluid are S.I & C.I. ....etc

[:=Read Full Message Here=:]

Hi
I need the write up for the code used in generating a graph of the compression ratio of a Otto engine to its efficiency. I don't have any idea on how to write the code. thanks ....etc

[:=Read Full Message Here=:]