Specifaction of SPRS system.
SPRS used form what Rating in HP.(Min HP requried of SPRS installtion in motor)
....etc

[:=Read Full Message Here=:]

Ultra Low-Power Clocking Scheme Using Energy Recovery and Clock Gating

Hamid Mahmoodi, Member, IEEE, Vishy Tirumalashetty, Matthew Cooke, and Kaushik Roy, Fellow, IEEE


Abstract—
A significant fraction of the total power in highly synchronous systems is dissipated over clock networks. Hence, low power clocking schemes are promising approaches for low-power design. We propose four novel energy recovery clocked flip-flops that enable energy recovery from the clock network, resulting in significant en ....etc

[:=Read Full Message Here=:]

AIM :
To conduct a direct load test on a 3-phase slip ring induction motor and to draw the performance characteristics.
FUSE RATING-
FOR- STATOR- 125% 0f 7.5A = 10A
FOR ROTOR – 125% of 11A = 15A
THEORY:
Slip ring induction motor is also called as phase wound motor. The motor is wound for as many poles as the no. of stator poles and always wound 3-Ф even while the stator is wound two-phase. The other three windings are brought out and connected to three insulated slip-rings mounted on t ....etc

[:=Read Full Message Here=:]

hi, i am asking about slip power recovery in induction motor ....etc

[:=Read Full Message Here=:]

Advantages and disadvantages of radial and closed ring ....etc

[:=Read Full Message Here=:]

I need the ppt of slip ring induction motor
K can u show me the ppt of slip ring induction motor
....etc

[:=Read Full Message Here=:]

WHY IS THE SLIP POWER RECOVERY SCHEME SUITABLE MAINLY FOR DRIVES WITH A LOW SPEED RANGE? ....etc

[:=Read Full Message Here=:]

Please give me a project report or else implementation strategy of slip power
recovery of wound rotor induction motor. ....etc

[:=Read Full Message Here=:]

hi am vijina k, doing m-tech .i would like to get details on load test on 3 phase slip ring induction motor pdf including circuit diagram and sample graphs...... thanks in advance. ....etc

[:=Read Full Message Here=:]

AIM
To conduct load test on three-phase Slip Ring induction motor.
APPARATUS REQUIRED
PRECAUTION
The motor should be started without any load.
PROCEDURE
1. Connections are given as per the circuit diagram.
2. The TPST’S is closed and the motor is started using online starter to run at rated speed.
3. At no load the speed, current, voltage and power are noted down.
4. By applying the load gradually with the help of spring balance and brake drum arrangements.
5. The speed, current, voltage, po ....etc

[:=Read Full Message Here=:]