Hello.......iam doing my project using APR6016....I have a problem while writing program for spi and apr6016 interfacing...So,please give some information about the programming of 6016 ....etc

[:=Read Full Message Here=:]

ABSTRACT
I2C is a serial interchip communication protocol used for data transfer between chips developed by Philips in order over come the drawback of PCB complexity due to parallel communication which requires 8 pin interface between the chips with the I2C protocol this 8 pins can be reduced to only 2 lines one is data line and one is clock line.
Many devices such RTC, EEPROM, Temperature sensor etc will come with inbuilt I2C engine which helps in reducing the consumption of micro controller pins which is got t ....etc

[:=Read Full Message Here=:]

A Swarm-Intelligence-Based Protocol for Data Acquisition in Networks with Mobile Sinks- IEEE TRANSACTIONS ON MOBILE COMPUTING, VOL. 7, NO. 8,
-Glomosim

Abstract—
This paper addresses the problem of data acquisition in ad hoc and sensor networks with mobile sinks and proposes a protocol based on swarm intelligence, SIMPLE, to route data in such environments. The proposed protocol is based on a swarm agent that integrates the residual energy of nodes into the route selection mechanism and maximizes the network’s lifetime by even ....etc

[:=Read Full Message Here=:]

looking for data transfer between two computers using spi protocol.not yet understood ....etc

[:=Read Full Message Here=:]

LITERATURE SURVEY

It is history to exchange data between various IC chips, at very high speeds; say, at 10 MHz or even more. Due to this high-speed aspect, the bus lines that will be used for communication cannot be too long, because their reactance increases too much, and the bus becomes unusable. The best and the most apt solution for this query is SPI bus. SPI stands for Serial to Peripheral Interface, and it is a hardware and firmware communications protocol developed by ....etc

[:=Read Full Message Here=:]

Data Acquisition and Data Logging



What is data acquisition and data logging
Data acquisition is simply the “gathering of information about a system or process”
Information may be gathered for various reasons
knowledge
research and development
systems or process monitoring
systems or process control
Data acquisition requires one or more transducers (sensors) to sense the system or process, and a signal measuring instrument

What is data ....etc

[:=Read Full Message Here=:]

i need the code to interface eeprom of lpc2138 based rich board....using i2c protocol.... ....etc

[:=Read Full Message Here=:]

circuit diagram for automatic dialing to any telephone using i2c photocol on detecting burglary
....etc

[:=Read Full Message Here=:]

Can you please provide me with the details of this MEMS Project which would be of great help in my project.

1.Which sensor was used?
2.Details about the design?
....etc

[:=Read Full Message Here=:]

PC Based data acquisition system by stimulating SPI and I2C protocol

Many times it is required to monitor physical phenomena such as temperature, pressure humidity, light intensity, sound intensity, force, etc. Such physical phenomena can be monitored by digital systems employing sensors. However sensor generally produces a change in the resistance, voltage or current. All such phenomena can be converted in to a change in voltage levels. Since the sensors and the subsequent signal conditioning circuits provide a proportionate change in volta ....etc

[:=Read Full Message Here=:]