Hello.......iam doing my project using APR6016....I have a problem while writing program for spi and apr6016 interfacing...So,please give some information about the programming of 6016 ....etc

[:=Read Full Message Here=:]

LITERATURE SURVEY

It is history to exchange data between various IC chips, at very high speeds; say, at 10 MHz or even more. Due to this high-speed aspect, the bus lines that will be used for communication cannot be too long, because their reactance increases too much, and the bus becomes unusable. The best and the most apt solution for this query is SPI bus. SPI stands for Serial to Peripheral Interface, and it is a hardware and firmware communications protocol developed by ....etc

[:=Read Full Message Here=:]

PC Based data acquisition system by stimulating SPI and I2C protocol

Many times it is required to monitor physical phenomena such as temperature, pressure humidity, light intensity, sound intensity, force, etc. Such physical phenomena can be monitored by digital systems employing sensors. However sensor generally produces a change in the resistance, voltage or current. All such phenomena can be converted in to a change in voltage levels. Since the sensors and the subsequent signal conditioning circuits provide a proportionate change in volta ....etc

[:=Read Full Message Here=:]

i want full report on i2c implementation using arm for wireless communication ....etc

[:=Read Full Message Here=:]

circuit diagram for automatic dialing to any telephone using i2c photocol on detecting burglary
....etc

[:=Read Full Message Here=:]

Using the I2C Bus
Judging from my emails, it is quite clear that the I2C bus can be very confusing for the newcomer. I have lots of examples on using the I2C bus on the website, but many of these are using high level controllers and do not show the detail of what is actually happening on the bus. This short article therefore tries to de-mystify the I2C bus, I hope it doesn't have the opposite effect!

The physical I2C bus
This is just two wires, called SCL and SDA. SCL is the clock line. It is us ....etc

[:=Read Full Message Here=:]

i need the code to interface eeprom of lpc2138 based rich board....using i2c protocol.... ....etc

[:=Read Full Message Here=:]

ABSTRACT
I2C is a serial interchip communication protocol used for data transfer between chips developed by Philips in order over come the drawback of PCB complexity due to parallel communication which requires 8 pin interface between the chips with the I2C protocol this 8 pins can be reduced to only 2 lines one is data line and one is clock line.
Many devices such RTC, EEPROM, Temperature sensor etc will come with inbuilt I2C engine which helps in reducing the consumption of micro controller pins which is got t ....etc

[:=Read Full Message Here=:]

looking for data transfer between two computers using spi protocol.not yet understood ....etc

[:=Read Full Message Here=:]

Can you please provide me with the details of this MEMS Project which would be of great help in my project.

1.Which sensor was used?
2.Details about the design?
....etc

[:=Read Full Message Here=:]