OPTIMIZATION OF CURE CYCLE TIME OF A BIAS TRUCK LUG TYRE BY STUDYING THE CURE EQUIVALENTS IN ISOTHERMAL AND NON-ISOTHERMAL CONDITIONS


INTRODUCTION
Curing is a process in which the viscoelastic rubber is converted into three-dimensional networks by tying up of all independent chains. Uncured rubber is a viscoelastic fluid, which has poor physical properties and undergoes deformation easily. Curing process reduces the flow of rubber material. And also reduces the amount of permanent deformation after the removal of deforming ....etc

[:=Read Full Message Here=:]

ABSTRACT
Complex tyre behavior is a direct result of the tyre construction. While looking much like a simple rubber doughnut attached to the rim, the tyre construction is vastly more complex, the two main functions of the tyre, is force generation in the road plane and suspension of the vehicle mass. The force generation is made possible by the rubber tread, causing a high friction coefficient with the road surface. The suspension of the vehicle mass is managed by the belt, radial cords and beads. The ....etc

[:=Read Full Message Here=:]

i want to be aware about the work which is done at the truck machine shop at dlw. ....etc

[:=Read Full Message Here=:]

Abstract ”
Developing open mobile robot has been a hot topic in AI area. In an open system, a particular component can be easily added and/or replaced. In this paper, a modular and object oriented approach is used to construct an autonomous mobile robot system. IPC (interprocess communication), which is the key mechanism in Linux/Unix operation system, is applied to the robot design. Based on Windows operation system, the robot owns an omnivision, and can finish tasks such as navigation and robot soccer. With a modular design, new compo ....etc

[:=Read Full Message Here=:]

i have to need of some basic information about the work which is done at dlw varansi ....etc

[:=Read Full Message Here=:]

vThe ultimate goal of our project is to transmit information from a computer, through wireless communication, to control the mobility of a robot on wheels. Infrared sensors will be a feature to detect objects within a given distance. Several areas of electrical engineering are being addressed within this project: the communication between objects by wireless radio frequencies, the control of the robot's servomotors, an algorithm communicating data to a computer communication port, and the programming and understanding of micro controllers. The ....etc

[:=Read Full Message Here=:]

abstract and literature review for hydraulic pallet truck ....etc

[:=Read Full Message Here=:]

ABSTRACT
Four simple, low cost aerodynamic drag reduction devices have been developed for application to
the trailer of a tractor-trailer truck. Two vortex flow devices have undergone extensive
operational fleet testing where they have amassed over 85,000 miles of use. These two vortex
flow technologies have shown a combined fuel savings of 8% at an average speed of 47.5 mph.
This improvement in fuel economy correlates to an equivalent drag reduction of approximately
20% with a corresponding drag coefficient of 0.45. Observations ....etc

[:=Read Full Message Here=:]

Can you please share the full report ?? Please share!!! ....etc

[:=Read Full Message Here=:]

please send me report of stair climber which have capacity of 5kg
....etc

[:=Read Full Message Here=:]