i have to need of some basic information about the work which is done at dlw varansi ....etc

[:=Read Full Message Here=:]

please send me report of stair climber which have capacity of 5kg
....etc

[:=Read Full Message Here=:]

Introduction

In general the forklift can be defined as a tool capable of lifting hundreds of kilograms. A forklift is a vehicle similar to a small truck that has two metal forks on the front used to lift cargo. The forklift operator drives the forklift forward until the forks push under the cargo, and can then lift the cargo several feet in the air by operating the forks. The forks, also known as blades or tines, are usually made out of steel and can lift up to a few tons.
Forklifts are either powered by gasoline, propane, o ....etc

[:=Read Full Message Here=:]

ABSTRACT
Four simple, low cost aerodynamic drag reduction devices have been developed for application to
the trailer of a tractor-trailer truck. Two vortex flow devices have undergone extensive
operational fleet testing where they have amassed over 85,000 miles of use. These two vortex
flow technologies have shown a combined fuel savings of 8% at an average speed of 47.5 mph.
This improvement in fuel economy correlates to an equivalent drag reduction of approximately
20% with a corresponding drag coefficient of 0.45. Observations ....etc

[:=Read Full Message Here=:]

OPTIMIZATION OF CURE CYCLE TIME OF A BIAS TRUCK LUG TYRE BY STUDYING THE CURE EQUIVALENTS IN ISOTHERMAL AND NON-ISOTHERMAL CONDITIONS


INTRODUCTION
Curing is a process in which the viscoelastic rubber is converted into three-dimensional networks by tying up of all independent chains. Uncured rubber is a viscoelastic fluid, which has poor physical properties and undergoes deformation easily. Curing process reduces the flow of rubber material. And also reduces the amount of permanent deformation after the removal of deforming ....etc

[:=Read Full Message Here=:]

VTEC (standing for Variable valve Timing and lift Electronic Control) is a system developed by Honda to improve the combustion efficiency of its internal combustion engines throughout the RPM range. This was the first system of its kind and eventually led to different types of variable valve timing and lift control systems that were later designed by other manufacturers (VVTL-i from Toyota, VarioCam Plus from Porsche, and so on). It was invented by Honda's chief engine designer Kenichi Nagahiro. ....etc

[:=Read Full Message Here=:]

abstract and literature review for hydraulic pallet truck ....etc

[:=Read Full Message Here=:]

ABSTRACT
Complex tyre behavior is a direct result of the tyre construction. While looking much like a simple rubber doughnut attached to the rim, the tyre construction is vastly more complex, the two main functions of the tyre, is force generation in the road plane and suspension of the vehicle mass. The force generation is made possible by the rubber tread, causing a high friction coefficient with the road surface. The suspension of the vehicle mass is managed by the belt, radial cords and beads. The ....etc

[:=Read Full Message Here=:]

i want to be aware about the work which is done at the truck machine shop at dlw. ....etc

[:=Read Full Message Here=:]

Can you please share the full report ?? Please share!!! ....etc

[:=Read Full Message Here=:]