I am interest in inplant training of railway department i am studying in B.E CSE ....etc

[:=Read Full Message Here=:]

Hiiii ... For attending inplant training in Madurai Railways...Whom we have to ask for permission??? ....etc

[:=Read Full Message Here=:]

COACHING DEPOT SOUTHERN RAILWAY
IV report



INDUSTRIAL TRAINING
Industrial training refers to work experience that is relevant to professional development prior to graduation. It provides pre-professional work experience with specific assignments and responsibilities. An industrial training should be relevant to a student's personal career interests and academic courses of study. Productive industrial trainings helps students make informed decisions and improve thei ....etc

[:=Read Full Message Here=:]

From,
         R. Nishanth, 
         EEE-3rd year,
         Theni(dt).
To,
      The officer,
      Southern raliway madurai, 
      Madurai. 
Respected sir, 
             I am nishanth. I am studying in vel tech engineering college at avadi,chennai.i need a implant training in southern railway madurai. Please give a implant training for me in our railway board madurai.it will help to my carrier in future. 
                           Thanking you, ....etc

[:=Read Full Message Here=:]

OPTIMIZATION OF CURE CYCLE TIME OF A BIAS TRUCK LUG TYRE BY STUDYING THE CURE EQUIVALENTS IN ISOTHERMAL AND NON-ISOTHERMAL CONDITIONS


INTRODUCTION
Curing is a process in which the viscoelastic rubber is converted into three-dimensional networks by tying up of all independent chains. Uncured rubber is a viscoelastic fluid, which has poor physical properties and undergoes deformation easily. Curing process reduces the flow of rubber material. And also reduces the amount of permanent deformation after the removal of deforming ....etc

[:=Read Full Message Here=:]

We want to attend inplant training in madurai ....etc

[:=Read Full Message Here=:]

ABSTRACT
Complex tyre behavior is a direct result of the tyre construction. While looking much like a simple rubber doughnut attached to the rim, the tyre construction is vastly more complex, the two main functions of the tyre, is force generation in the road plane and suspension of the vehicle mass. The force generation is made possible by the rubber tread, causing a high friction coefficient with the road surface. The suspension of the vehicle mass is managed by the belt, radial cords and beads. The ....etc

[:=Read Full Message Here=:]

i want to be aware about the work which is done at the truck machine shop at dlw. ....etc

[:=Read Full Message Here=:]

ABSTRACT
Four simple, low cost aerodynamic drag reduction devices have been developed for application to
the trailer of a tractor-trailer truck. Two vortex flow devices have undergone extensive
operational fleet testing where they have amassed over 85,000 miles of use. These two vortex
flow technologies have shown a combined fuel savings of 8% at an average speed of 47.5 mph.
This improvement in fuel economy correlates to an equivalent drag reduction of approximately
20% with a corresponding drag coefficient of 0.45. Observations ....etc

[:=Read Full Message Here=:]

FROM :
             R.selvakumar
            EEE-3rd year
            Theni kammavar sangam college of technology
            Theni.
[font=Verdana, sans-s ....etc

[:=Read Full Message Here=:]