Frequency modulation


The fi rst public broadcast radio services introduced in the 1920s were in
the long-wave (LW) and then medium-wave (MW) band, using amplitude
modulation (AM) and limited by the technology of the time. Historically,
long- and medium-wave AM broadcasting has used restricted bandwidth,
approximately 4 kHz, which allows intelligible speech but is not very good
for music broadcasting, since music signals are typically 14–20 kHz in bandwidth.
Amplitude modulatio ....etc

[:=Read Full Message Here=:]

METHODS OF FREQUENCY MODULATION



METHODS OF FREQUENCY MODULATION. - The circuit shown earlier in figure 2-6 and the discussion in previous paragraphs were for illustrative purposes only. In reality, such a circuit would not be practical. However, the basic principle involved (the change in reactance of an oscillator circuit in accordance with the modulating voltage) constitutes one of the methods of developing a frequency-modulated wave.

Reactance-Tube ....etc

[:=Read Full Message Here=:]

Sir I am in a need of ppt for my miniproject amplitude &frequency modulation&demodulation using ICNE566. ..so kindly reply me ....etc

[:=Read Full Message Here=:]

Introduction
The basic Frequency Modulation communications system has:
1) Transmitter, which is the sub-system that takes the information signal and processes it prior to transmission. The transmitter modulates the information onto a carrier signal and broadcasts it over the channel
2) Channel: The medium which transports the modulated signal to the receiver. In this project, LED will be connected to FM transmitter end. Signals then will be picked up by the Photo Detector diode right before the FM Receiver
3) ....etc

[:=Read Full Message Here=:]

please provide me the bstract and ful details of this project. ....etc

[:=Read Full Message Here=:]

ppt presentation on wide band frequency modulation ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Amplitude &Frequency Modulation



Modulation Methods

In the modulation process, some characteristic of a high-frequency
sinusoidal carrier is changed in direct proportion to the instantaneous
amplitude of the baseband signal. The carrier itself can be
described by the equation


Zero Span and Markers


One possibility, if the percent modulation is high enough, is
to use the analyzer as a fixed-tuned receiver, demodulate
the signal using the envelope detector ....etc

[:=Read Full Message Here=:]

A High Data Rate Frequency Hopping Modulation Scheme
Theme:ECE/Digital Communications

Submited By:
Hemanth Patnala
R.V.Seshu Kumar
Sir C.R.R. College Of Engineering,
Eluru-534002
ABSTRACT
There is a need to select the 'first step up' modulation scheme for higher data rate frequency hopping systems. This is seen as one step in a longer journey where considerably higher data rates are used. In order to make this progression viable, the first step should be taken with a well proven modulation scheme. An ....etc

[:=Read Full Message Here=:]

can u please send furthur information about adaptive modulation performance of wideband OFDM communications to my mail [email protected] ....etc

[:=Read Full Message Here=:]