A Project Report on
Simulation Testbed for Evaluation of
Critical Software in Launch Sequence
Submitted in Partial fulfillment of the requirements for the award of
the degree of
Master of Technology
In
Software Engineering
Submitted by
Sreebal I S
Under the Esteemed Guidance of
Mr. Santhosh Kumar G
Lecturer
Dept. of Computer Science, CUSAT
DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY,
KOCHI-682022, KERALA
JUNE 2008Page 2
Page 3

DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND ....etc

[:=Read Full Message Here=:]

Single-Electron Transistor (SET) Process and Device Simulation Using SYSNOPSYS TCAD Tools
Abstract:
Simulation of semiconductor device fabrication and operation is important to the design and manufacture of integrated circuits because it provides insights into complex phenomena that cannot obtained through experimentation or simple analytic models. Process and device simulation is commonly using for the design of new very large scale integration (VLSI) devices and processes. Simulation programs serves as exploratory tools in o ....etc

[:=Read Full Message Here=:]

2 cstr separated by a plug flow of deadtime d,develop a model ....etc

[:=Read Full Message Here=:]

I'm a final working on pedal powered n I would like to b help with the methodology of the project ....etc

[:=Read Full Message Here=:]

Under the Guidance of Dr. Patil Basavaraj VDept of IP & E
Submitted By Deepak Kothari

Introduction to CWR

The CWR is a rotary forming process, consists
of the forming of forging by means of wedge-shaped tools that are fixed on the mill rolls with the same rotary direction.
In CWR process, there are five stages in the work piece deformation process corresponding to five zones of the wedged tool geometry, i.e., knifing, guiding, stretching, shaping, and siz ....etc

[:=Read Full Message Here=:]

CPU Scheduler A Simulation ....etc

[:=Read Full Message Here=:]

Finite-Element Simulation of Electrical Discharge Machining (EDM) Process


I. INTRODUCTION
Electric discharge machining (EDM), sometimes
colloquially also referred to as spark machining, spark
eroding, burning, die sinking or wire erosion, is a
manufacturing process whereby a desired shape is obtained
using electrical discharges (sparks). Material is removed
from the workpiece by a series of rapidly recurring current
discharges between two electrodes, se ....etc

[:=Read Full Message Here=:]

Abstract
Wireless sensor networks provide the smallest and cheapest form of wireless communicating and computing devices due to the advances in Processor, memory and radio technology. These wireless sensor networks pose significantly different design, implementation, and deployment challenges. In this project, I present a simulation of the wireless sensor network for paging applications. These pagers can provide small data transfer and can be used to transfer small pieces of information between themselves. A pager is a wireless sensor mote wh ....etc

[:=Read Full Message Here=:]

this is ruby tripathi. i vl apload any new topic and my search related to any project. i will help students inn their work..
....etc

[:=Read Full Message Here=:]

AUTO FLIGHT PILOT SIMULATION APPLIED IN REAL TIME AND REMOTE MONITORING USING HIGH SPEED RF DATA LINK FOR UAV / FLIGHT.

ABSTRACT: The use of Unmanned Arial Vehicle (UAV) become vital in the modern world as the activities of UAV is unequal. The main navigation system used in the UAV is a remote controlled pilot system. The real pilot, who is sitting remotely with all control equipment and monitoring system become a real cockpit and it is necessary to control all parameters in real time at higher accuracy.
The project mentioned here is the re ....etc

[:=Read Full Message Here=:]