Jainaba Jagne/ Serengul Smith/ Paul Curzon/ Elke Duncker

ABSTRACT
In this paper we address the integration of cultural and social factors of metaphors into cross-cultural interface design. We argue that there is an emerging need to look into the doctrine behind the metaphors being used based on the national culture of the target market rather than relying on existing “Western” theories. In other words if one needs to identify some of the issues that might be pertinent to the d ....etc

[:=Read Full Message Here=:]

please send the report and ppt on the topic ultrasonic techniques for hidden corrosion detection ....etc

[:=Read Full Message Here=:]

Presented by:
Hong Lu
Nicholas D. Lane
Shane B. Eisenman
Andrew T. Campbell



Abstract

We propose Bubble-Sensing, a new sensor network abstraction that allows mobile phones users to create a binding between tasks (e.g., take a photo, or sample audio every hour indefinitely) and the physical world at locations of interest, that remains active for a duration set by the user. We envision mobile phones being able to affix task bubbles at places of interest and then receive sensed data as it becomes ....etc

[:=Read Full Message Here=:]

Abstract
Laser assisted direct metal deposition refers to the additive layered manufacturing technology for building components from a
computer-aided design CAD. model. A motion control program, developed from the CAD model of a desired metal component,
is used to control the motion of a laser focal spot to trace all areas of the part, typically a planar layer at a time. Metal powders,
injected into the laser focal zone, are melted and then re-solidify into fully dense metal in the wake of the moving molten pool
created by the las ....etc

[:=Read Full Message Here=:]

SPUTTERING
OR
Physical Vapor Deposition – Evaporation
and Sputtering

Dr. Lynn Fuller
Microelectronic Engineering
Rochester Institute of Technology
82 Lomb Memorial Drive
Rochester, NY 14623-5604


EVAPORATION TECHNIQUES
Aluminum - evaporate copper with tungsten wire basket. One pellet at 20 cm gives about 3000 A. Copper - evaporate copper with tungsten wire basket. The basket needs to be crushed a little so the openings are small and the copper does not fal ....etc

[:=Read Full Message Here=:]

Abstract

To analyze a new endodontic sealer material commercially known as Resilon and to describe in detail the experimental techniques employed that lead to the identification of the composite material.
Methods

An extensive structural, thermal, and physical characterization was used to identify a new endodontic sealer material using the following techniques: Fourier transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) analysis, X-ray fluorescence spectrometry (XRF) technique, X-ray diffraction (XRD) measurement, th ....etc

[:=Read Full Message Here=:]

Presented by:
Hong Lu
Nicholas D. Lane
Shane B. Eisenman
Andrew T. Campbell


Abstract

We propose Bubble-Sensing, a new sensor network abstraction that allows mobile phones users to create a binding between tasks (e.g., take a photo, or sample audio every hour indefinitely) and the physical world at locations of interest, that remains active for a duration set by the user. We envision mobile phones being able to affix task bubbles at places of interest and then receive sensed data as it becomes available in a delay-t ....etc

[:=Read Full Message Here=:]

Rajesh Bathija, Mewar University

Physical Design Cycle
Partitioning
Floorplanning
Placement
Global & Detail Routing
Layout Compaction
Layout verification

Partitioning

Partitioning is the task of dividing a circuit into smaller parts . The objective is to partition the circuit into parts, so that the size of each component is within prescribed ranges and the number of connections between the components is minimized .
Different ways to partition correspond t ....etc

[:=Read Full Message Here=:]

Please send me the report of the topic ultra sonic techniques for hidden corrosion detection ....etc

[:=Read Full Message Here=:]

Thermophoresis is a phenomenon of the movement of small particles in a gas with a temperature gradient towards the cooler region of the gas. Small particles, such as dust, when suspended in a non-isothermal gas, experience a force in the direction opposite to the temperature gradient. This force, known as the thermophoretic force plays an important role in the mass transfer mechanism of several devices involving sub-micron and micron sized particles and a large thermal gradient, and it is often cited as an important one influence the efficiency ....etc

[:=Read Full Message Here=:]