CCA (CCS) Rules-1965

CCA (CCS) Rules-1965
SHORT TITLE AND COMMENCEMENT
CENTRAL CIVIL SERVICES(CLASSIFICATION, CONTROL & APPEAL) RULES, 1965
POWERS CONFERRED BY PROVISO TO ARTICLE 309 AND CLAUSE (5) OF ARTICLE 148 OF THE CONSTITUTION
THEY SHALL COME INTO FORCE ON THE 1ST DECEMBER, 1965.
INTERPRETATION
APPOINTING AUTHORITY:
The authority empowered to make appointments to the service of which the government servant is for the time being a member or to the grade of the service in which the government servant is for ....etc

[:=Read Full Message Here=:]

please, i need ccs code for active noise cancellation T_T ....etc

[:=Read Full Message Here=:]

PCM PRINCIPLES&CAS,CCS#7-TRAINING PROJECT REPORT AT ALTTC GHAZIABAD(BSNL)


Pulse Code Modulation (PCM)
Principles
Analog transmission is not particularly efficient. When the signal-to-noise ratio of an analog signal deteriorates due to attenuation, amplifying the signal also amplifies noise. Digital signals are more easily separated from noise and can be regenerated in their original state. The conversion of analogue signals to digital signals therefore eliminates the problems c ....etc

[:=Read Full Message Here=:]

clc;
ccsboardinfo %board info
cc=ccsdsp('boardnum',0); %set up CCS object
reset(cc); %reset board
visible(cc,1); %for CCS window
enable(cc.rtdx); %enable RTDX
if ~isenabled(cc.rtdx);
error('RTDX is not enabled')
end
cc.rtdx.set('timeout',50); %set 50sec timeout for RTDX
open(cc,'spectrogram1.pjt'); %open CCS project
load(cc,'./debug/spectrogram1.out'); %load executable file
run(cc); %run program
configure(cc.rtdx,2048,1); %configure one RTDX channel
open(cc.rtdx,'ochan','r'); %open output ch ....etc

[:=Read Full Message Here=:]

This version of project makes use of RTDX with MATLAB for transferring data from the DSK to the PC host. This section introduces configuration file(.CDB) file and RTDX with MATLAB.
This project uses source program spectrogram_rtdx_mtl.c that runs on the DSK which computes 256 point FFT and enables an RTDX output channel to write/send the resulting FFT data to the PC running MATLAB for finding the spectrogram. A total of N/2 (128 points )are sent. The (.CDB) configuration file is used to set interrupt INT11. From this configuration file select ....etc

[:=Read Full Message Here=:]

matlab code for implementation of csma cd in matlab ....etc

[:=Read Full Message Here=:]

I am looking for matlab code shadow detection and removal in rgb images using matlab, anybody can help me? ....etc

[:=Read Full Message Here=:]

PRESENTED BY :
PAVAN.A & ASHISH


Introducing PowerPoint 2007
 WHAT IS CCS?
 CCS is a system of technologies that integrates three stages: CO2 capture, CO2 transport and geologic CO2 storage.
 Various technologies with different degrees of maturity are competing to be the low-cost solution for each stage of the CCS value chain
 FUEL
 COAL AS A MAJOR SOURCE
 COAL IN INDIA
 Usage of coal foe generation of power results in the production on co2
 From the graph it evide ....etc

[:=Read Full Message Here=:]

B = FIR1(N,Wn) designs an N'th order lowpass FIR digital filter
and returns the filter coefficients in length N+1 vector B.
The cut-off frequency Wn must be between 0 < Wn < 1.0, with 1.0
corresponding to half the sample rate. The filter B is real and
has linear phase, i.e., even symmetric coefficients obeying B(k) =
B(N+2-k), k = 1,2,...,N+1.
If Wn is a two-element vector, Wn = , FIR1 returns an
order N bandpass filter with passband W1 < W < W2.
B = FIR1(N,Wn,'high') designs a highpa ....etc

[:=Read Full Message Here=:]

entropy coding after quantization ....etc

[:=Read Full Message Here=:]