Abstract-
A pulse skipping control strategy is proposed to improve efficiency of grid-tied inverters at light loads. To maximize the efficiency of pulse skipping operation mode, three key parameters are identified and optimized based on a loss model, which is developed to find the maximal efficiency points using a three-dimensional search technique. A 200W prototype inverter was setup to verify the proposed control strategy. The experimental results show that the proposed pulse skipping control strategy greatly impr ....etc

[:=Read Full Message Here=:]

Introduction

An inverter is an electrical device that converts direct current (DC) to alternating current (AC); the converted AC can be at any required voltage and frequency with the use of appropriate transformers, switching, and control circuits.
Static inverters have no moving parts and are used in a wide range of applications, from small switching power supplies in computers, to large electric utility high-voltage direct current applications that transport bulk power. Inverters are co ....etc

[:=Read Full Message Here=:]

1. Design and Implementation of Microcontroller based PWM technique for Sine wave Inverter
2. A novel DC-AC Single Phase Resonant Inverter using soft switching boost converter
3. Study on Dual-Loop Grid Current Control Scheme for Grid-Connected Inverter with an LCL-Filter
4. ZVS H-bridge Inverter using Soft Switching Boost Converter
5. A Novel Hybrid Modulation Scheme for an Isolated High-Frequency-Link Fuel Cell Inverter
6. ZVS Resonant DC-link Inverter using Soft Switching Boost Converter
7. Comparison of Z-Source Inverter and Traditi ....etc

[:=Read Full Message Here=:]

4.6 NUETRAL POINT CLAMPED (NPC) INVERTERS


Known as three-level inverters

Problem of 2-level inverter in high-power applications
High DC page link voltage requires series connection of devices  difficulty in dynamic voltage sharing during switching

Solved using NPC inverter or multilevel inverter

NPC inverter circuit


NPC (3)

DC page link capacitor split to create neutral point 0

Q11, Q14 : main devices (2-level inverter)

Q12, Q13 : auxiliary devices – clamp output potential to ne ....etc

[:=Read Full Message Here=:]

I need materials regarding Generation of gate signal for converter and inverter using PIC18F ....etc

[:=Read Full Message Here=:]

MULTI LEVEL INVERTERS (MLI)



MLI (2)


Diode-clamped multilevel inverter (DCMI)
Extension of NPC
Based on concept of using diodes to limit power devices voltage stress
Structure and basic operating principle
Consists of series connected capacitors that divide DC bus voltage into a set of capacitor voltages

A DCMI with nl number of levels typically comprises (nl-1) capacitors on the DC bus

Voltage across each capacitor is VDC/(nl-1)
( nl ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Abstract
In adjustable speed drive applications, the switching of the inverter semiconductors generates common
mode currents as well as harmful overvoltages on the motor terminals when long cables are used.
Consequently, bulky and expensive input and output filters must be used. This work aims at reducing
these disturbances from their origin by using a three-level neutral-point-clamped (NPC) inverter
controlled with a new pulse-width-modulation (PWM) strategy. Whereas previous common mode
noise-reducing strate ....etc

[:=Read Full Message Here=:]

PRESENTED By
SUDHAKAR AKKI


SPACE VECTOR MODULATION FOR TWO LEG INVERTERS
INTRODUCTION
• Semiconductor switches mainly determine the overall price of power converters.
• The main objective of this project is to prove 2leg inverters are the best option for low power applications for getting the good performance.
• Two leg inverter produces the square wave or quasi-square wave. but low power applications allow the two leg inverter output.
• In many industrial applications, it is often required to v ....etc

[:=Read Full Message Here=:]

Abstract
Two major factors that limit the throughput inmulti-hop wireless networks are the unreliability of wirelesstransmissions and co-channel interference. One promising techniquethat combats lossy wireless transmissions is opportunisticrouting (OR). OR involves multiple forwarding candidates torelay packets by taking advantage of the broadcast nature andspacial diversity of the wireless medium. Furthermore, recentadvances in multi-radio multi-channel transmission technologyallows more concurrent transmissions in the network, and sh ....etc

[:=Read Full Message Here=:]