I need the code of maze solving robot of atmega 16 microcontroller ....etc

[:=Read Full Message Here=:]

Sir

I have seen the abstract of the project which matches with my projects but only few topics are there in the page can you give me the whole project on 'Transient stability analysis of single machine system' using runge kutta 4th order method using matlab code

regards
digg_777 ....etc

[:=Read Full Message Here=:]

INTRODUCTION
DEFINE :- A pair of linear equations in two variables is said to form a system of simultaneous linear equations
The general form of pair of linear equations in two variables x and y is :-
a1x + b1y + c1 = 0
a2x + b2y + c2 = 0
METHODS
The Algebraic Methods of solving simultaneous pair Linear Equations in Two Variables are :-
1) METHOD OF ELIMINATION BY SUBSTITUTION
2) METHOD OF ELIMINATION BY EQUATING THE COEFFICIENTS
3) METHOD OF CROSS-MULTIPLICATION
....etc

[:=Read Full Message Here=:]

any body send this project to [email protected]
plzzzzzzzzzzzzz ....etc

[:=Read Full Message Here=:]

The micromouse is very much important in the field of robotics as it requires a complete analysis & proper planning to be solved. For solving the maze, several algorithms are discussed. very basic wall follower logic is first discussed followed by some sophisticated level such as the flood fill.

The Wall Follower Logic
Maze Interpretation
The maze consists of a 16x16 array of 18cmx18cm square. The micromouse has to reach the centre cell, which is the destination of the robot. the entire
maze has to be traversed by the rob ....etc

[:=Read Full Message Here=:]

Problem Solving

INTRODUCTION TO PROBLEM SOLVING

Engineers must analyze and solve a wide range of technical problems. Some will be reasonably simple single-solution problems. Others will be open-ended and will likely require a team of engineers from several disciplines. Some problems may have no clear solution.


• PROBLEM SOLVING INVOLVES:
– EXPERIENCE
– KNOWLEDGE
– PROCESS
– ART
FOCUS: Computer Assisted Problem Solving
Computers are good tools for solving rule-based problems ....etc

[:=Read Full Message Here=:]

Obstruction Detection & Auto Solving Vehicle
DESCRIPTION :
The main aim of this project is to show how the controllers are used in robots. According to our requirement we can program the robotic vehicle. Here our robotic vehicle is used to cross the box which is placed infront of the vehicle.
TECHNOLGY :
Sensor Technology.
WORKING :
This project uses AT89S52 microcontroller, Alpha Numeric LCD (16 x 2 Line), Motor Driver, Buzzer & Proximity Sensors. Three sensors are attached (which are in turn connected ....etc

[:=Read Full Message Here=:]

Request for code of maze solver robot.
I am trying to make maze solver robot using Atmega16, I have some problem.
My requirements are 1st robot should search he path using IR sensors after searching correct path 1st robot send data to other robot (wireless communication)
so that second robot can directly follow he correct path without moving on extra lines.
i need code for that. ....etc

[:=Read Full Message Here=:]

This project is aimed at analyzing the available methods for solving a system of linear equations of the form n x n. Using a couple of iterative and/or direct methods, implement a program for these methods that could be run on a parallel
processor. At the end, a graph can be plotted with time taken for execution of a method considered V/s number of processors used (2, 4, 8, 32). For example following questions need to be addressed “
1. For a method considered, evaluate that as the number of processors is increased does the time taken ne ....etc

[:=Read Full Message Here=:]

INTRODUCTION
This Project Grid solving Robot is based on 8 bit Microcontroller AT89S52.
This Robot follows the black line which is drawn over the white surface or it
follows the white line which is drawn over the black surface. The sensors
are used to sense the line. When the light signal falls on the white surface, it
gets reflected and if it falls on the black surface, it is not reflected, this
principle is used to scan the Lines for the Robot. All the above systems are
controlled by the Microcontroller. In o ....etc

[:=Read Full Message Here=:]