NTRODUCTION:

The predominant type of prime movers for DP propulsion plant is Electric Drive.


The most commonly used motor drives are:


DC converters, or SCR for DC motors.

Cyclo converters for AC motors ,normally for Synchronous motors .

Current Source Inverters (CSI) for Ac motors (Synchronous Motors )

Voltage Source Inverters ,(VSI)for AC motors ,i.e. asynchronous, ....etc

[:=Read Full Message Here=:]

respected sir/madam,
i saurabh kumar pran is doing b.tech(final yr.) from bharath university.i want little description regarding to the projectHall Effect sensor based non-contact Tachometer for electrical motors speed measurement. i also want to know what are the component used in this project and what is its expected cost.i have already worked on many sensing device in our previous semester mini project.if you have possible please send me block diagram of this project. i m highly obliged if you can ....etc

[:=Read Full Message Here=:]

I want to know the cost and disadvantages of written pole electric motor. So please reply ....etc

[:=Read Full Message Here=:]

Introduction
Electromechanical device that converts electrical energy to mechanical energy
Mechanical energy used to e.g.
Rotate pump impeller, fan, blower
Drive compressors
Lift materials
DC Motors – Components
Field pole
North pole and south pole
Receive electricity to formmagnetic field
Armature
Cylinder between the poles
Electromagnet when current goes through it
Linked to drive shaft to drive the load
Commutator
Overturns current direction in armature
AC Motors – Synchronous motor[/ ....etc

[:=Read Full Message Here=:]

Hi
I am looking for current pest analysis of Hyundai motors India 2012 and key drivers.

Please help ....etc

[:=Read Full Message Here=:]

PRESENTED BY:
MANJUNATHA B.E


Abstract-
 As the cost of energy increases it is increasingly more important to remove inefficient motors from operation.
 It describes the results of a very-low-cost & accurate method for determining the motor efficiency without the need for removing the motor & without the need for measuring the output power or torque.
 Test results indicate that the novel method has an accuracy of over 99%.
INTRODUCTION-
Methods:
1.To place the motor on a test stand ....etc

[:=Read Full Message Here=:]

i want to disadvantages of written pole electric motors ....etc

[:=Read Full Message Here=:]

POTENTIAL OF PIEZO ELECTRIC ECOFLOOR FOR GENERATION OF ELECTRIC POWER


The need to generate electricity is the demand for today’s life because of the fact that even if the planet doubles the amount of solar and wind power available, there would still be a shortage of clean electricity. Comparison of different forms of commercial power generation by use of the fuel cycle methods developed in European studies shows that the health burdens are extreme in areas where power stations (base ....etc

[:=Read Full Message Here=:]

send me the report about this topic. this is our main project. So send to me my email id is [email protected]
....etc

[:=Read Full Message Here=:]

Name– Study of basic gates.
Aim – to study the working of basic gates like AND gate, OR gate and NOT gate.
Apparatus – IC 7404, IC 7408, IC 7432, circuit board, power supply +5V DC, LED, connecting wires, soldering iron, cutter etc.


Procedure –
1) You are given IC 7404, IC 7408 and IC 7432. Identify the ICs by reading their numbers and details from above given pin configurations and specifications.
2) Solder the circuit as shown in the circuit diagram.
3) Connec ....etc

[:=Read Full Message Here=:]