Dear Sir,

Please help me to regarding Allowable stress values for Indian Mild Steel (IS 2062 Gr. A) for various temperature range Eg. -10 Deg C to Max. upper limit.

Thanks & Regard,

Vijay
....etc

[:=Read Full Message Here=:]

ABSTRACT

This test method covers determination of the compressive strength of hydraulic cement mortars, using 2-in. or cube specimens.Test Method C 349 provides an alternative procedure for this determination (not to be used for acceptance tests). This test method covers the application of the test using either inch-pound or SI units. The values stated in either system shall be regarded separately as standard. Within the text, the SI units are shown in brackets. ....etc

[:=Read Full Message Here=:]

1) INTRODUCTION
1.1 Basics of Bond Strength
a) Bond:-Bond in reinforcement refers to the adhesion between the reinforcing steel and the surrounding concrete.
b) Importance of Bond b/w steel and concrete:-The bond between the reinforcing steel and the surrounding concrete is responsible for the transfer of axial force from a reinforcing bar to surrounding concrete, thereby providing strain compatibility and composite action of concrete and steel. If this bond is in adequate, slipping of the reinforcing bar will occu ....etc

[:=Read Full Message Here=:]

what is the allowable stress
for carbon steel plates ....etc

[:=Read Full Message Here=:]

i have need some ppt's of compressive strength of cement. ....etc

[:=Read Full Message Here=:]

ABSTRACT
This report present a novel idea to capture and represent compressible signals for transmission and storage at a rate below the Nyquist rate. This method is known as compressive sampling/sensing employs non adaptive linear projections that preserve the structure of the signal. The signal is reconstruced from these projections using optimization techniques.




TABLE OF CONTENTS
1 Introduction 1
2 Data Compression 3
2.1 Types of Data Compression . . . . . . . . . . . . . . . . . . . . . . 5
2.1.1 Loss ....etc

[:=Read Full Message Here=:]

Strength based and Displacement Based Design method for steel


Abstract

The performance based seismic design of Steel moment resisting frame structures aimed at controlling the structural damage based on precise estimations of proper response parameters. The primary focus of this study is on the development of a detailed assessment of the inelastic seismic behavior, response, and performance of typical ductile Steel moment resisting frame structures. This research tries to assess the Strength based and Disp ....etc

[:=Read Full Message Here=:]

Abstract :

The case study project is significant since mild steel is used in structure, case hardening, gears, free cutting steels, shafting, forging etc. Mild steel plates were tested for mechanical properties like hardness, tensile strength, yield point etc. Later on the plates were joined by submerged arc welding and the mechanical properties were estimated again. Also weld ability, harden ability, tensile test etc. were conducted for the same result. ....etc

[:=Read Full Message Here=:]

My name harpreet singh from patiala ,Punjab
I have equipment to check the compression of mild steel . please send me a experiment repot of compressive strength of mildsteel.
compressive strength of mild steel whole experiment with observation? ....etc

[:=Read Full Message Here=:]

Gary Morphy
VARI-FORM

ABSTRACT
The need for lighter, stronger, more rigid vehicle structures will increasingly require complex hydroformed structural tubes to increase strength, and decrease weight, cost and part count. This effort will increase the use of high strength, low alloy (HSLA) steel, in place of SAE 1006/1008 or 1010 steel. Traditional hydroforming techniques require the higher elongation of the latter materials. An alternative tube hydroforming process has been d ....etc

[:=Read Full Message Here=:]