LOW POWER VLSI On CMOS full report
#1

LOW POWER VLSI On CMOS

Submitted by:
K.Nagendra


Why we go to Low Power..


PORTABILITY:
Enhanced run-time, Reduced weight, Reduced volume, Low cost operation
High Performance:
Low-cost cooling, Low-cost packaging, Low-cost operation
RELIABILITY:
Avoid thermal problems
Avoid scaling related problems



Where Does Power Go In CMOS

Dynamic Power Consumption : Charging and Discharging Capacitors
Short Circuit Currents : Short circuit path

between supply rails during switching
Leakage: Leakage diodes and

transistors
Ptotal = PDYN + PSC + PLeakage
=CLVDDF+VDDIPEAK{(Tr + Tf)/2}F+VDD ILEAK



Glitching¦
Glitching refers to spurious and unwanted transitions that occur before a node settle down to its final steady-state value.
Glitching often arises when paths with unbalanced propagation delay converges at the same point in the circuit.
The dissipation caused by the spurious transitions can reach up to 25% of the total dissipation for some circuits.



Short Circuit Currents
Short circuit currents are encountered only in static design.
In static CMOS circuits the flow current from VDD to GND during Switching when both NMOS and PMOS conducting Simultaneously.
Such path never exists in a dynamic circuits.



Short-Circuit energy as a function of slope ratio
Short-Circuit energy dissipation (normalized with respect to zero i/p rise time energy) for a static CMOS.
The power dissipation due to short circuit currents is minimized by matching the rise/fall times of the input and output signals.
Short-Circuit reduced by lower the Supply Voltage.


Conclusion
Thus the low power can be achieved by decreasing Vdd to certain level.
As leakage current cannot be reduced, the short circuit currents are eliminated by dynamic circuits.
The power dissipation due to short circuit currents is minimized by matching the rise/fall times of the input and output signals
Glitching makes power to dissipate so it is reduced by cope process
Reply
#2
please read http://citeseerx.ist.psu.edu/viewdoc/dow...1&type=pdf for getting full report
Reply
#3
[attachment=5692]
LOW POWER VLSI TECHNOLOGY


ABSTRACT

In the past, the major concerns of the VLSI design were area, performance, cost and reliability; power consideration was mostly of only secondary importance. In recent years, this has begun to change increasingly, power is being given comparable weight to area and speed considerations. High power systems often run hot; high temperature tends to exacerbate several silicon failure mechanisms. Every 10C increase in operating temperature roughly doubles a component’s failure rate.
The growth of personal computing devices (portable desktops, audio and video-based multimedia products) and wireless communications systems demand high-speed computation and complex functionality; with low power consumption. In this context, peak power (maximum possible power dissipation) is a critical design factor as it determines the thermal, electrical limits of designs; impacts the system cost, size and weight; dictates specific battery type, system packaging, heat sinks; aggravates the resistive and inductive voltage drop problems pointing to an ultimate solution- LOW POWER VLSI TECHNOLOGY.
Low power has emerged as a principal theme in today’s electronics industry. The need for low power has caused a major paradigm shift where power dissipation has become as important a consideration as performance and area. This article reviews various strategies and methodologies for designing low power circuits and systems. It describes the many issues facing designers at architectural, logic, circuit and device levels and presents some of the techniques that have been proposed to overcome these difficulties. The article concludes with the future challenges that must be met to design low power, high performance systems.
Reply
#4
can u pls send the full report document file of low power vlsi on cmos.
Reply
#5
hi friend, project report helper has already attached a doc in his post. hope it should contain full report.
Reply
#6
send the report as early as possible
Reply
#7
need full project report
Reply
#8
Please give me the detail report and PPT of this seminar for M.E.(E&TC).
Reply
#9


to get information about the topic"LOW POWER VLSI On CMOS full report" please refer the page link bellow

http://studentbank.in/report-low-power-v...ull-report
Reply
#10
hai .......... i want low power vlsi design papers for technical seminars. could u assist me.
Reply
#11


to get infornation about the topic"LOW POWER VLSI On CMOS full report"refer the page link bellow
http://studentbank.in/report-low-power-v...ull-report
Reply
#12
to get infornation about the topic"LOW POWER VLSI On CMOS full report"refer the page link bellow
http://studentbank.in/report-low-power-v...ull-report
Reply
#13
to get information about the topic "Low power VLSI" full report ppt and related topic refer the page link bellow

http://studentbank.in/report-low-power-vlsi

http://studentbank.in/report-low-power-v...ull-report

http://studentbank.in/report-trends-in-l...lsi-design
Reply
#14
good dvfn bhgn fhGN fhtjtjm dgfh uiihuhik jjixioalxd mkoiuug nkxaoiud nkhuDUGYVa jgyain c xsds
Reply
#15

To get full information or details of LOW POWER VLSI On CMOS please have a look on the pages


http://studentbank.in/report-low-power-vlsi

http://studentbank.in/report-low-power-v...ull-report


if you again feel trouble on LOW POWER VLSI On CMOS please reply in that page and ask specific fields in LOW POWER VLSI On CMOS
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Tagged Pages: vlsi low power seminars, low power consumption of vlsi topic seminar report,
Popular Searches: cmos circuits, low power vlsi on cmos pdf, cmos vlsi design, ppt on power dessipation in cmos, special purpose subsystems in cmos vlsi design ppt, seminar full report on vlsi, low power vlsi viva questions,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  Transparent electronics full report seminar surveyer 8 24,359 04-04-2018, 07:54 AM
Last Post: Kalyani Wadkar
  wireless charging through microwaves full report project report tiger 90 70,546 27-09-2016, 04:16 AM
Last Post: The icon
  Wireless Power Transmission via Solar Power Satellite full report project topics 32 50,219 30-03-2016, 03:27 PM
Last Post: dhanabhagya
  surge current protection using superconductors full report computer science technology 13 26,850 16-03-2016, 12:03 AM
Last Post: computer science crazy
  paper battery full report project report tiger 57 61,687 16-02-2016, 11:42 AM
Last Post: Guest
  IMOD-Interferometric modulator full report seminar presentation 3 11,364 18-07-2015, 10:14 AM
Last Post: [email protected]
  digital jewellery full report project report tiger 36 66,490 27-04-2015, 01:29 PM
Last Post: seminar report asees
  UNINTERRUPTIBLE POWER SUPPLIES ppt seminar surveyer 2 4,535 30-03-2015, 11:29 AM
Last Post: seminar report asees
  eddy current brake full report project report tiger 24 33,405 14-09-2014, 08:27 AM
Last Post: Guest
  BROADBAND OVER POWER LINE (BPL) seminar projects crazy 39 27,336 30-08-2014, 01:10 AM
Last Post: Guest

Forum Jump: