17-07-2013, 01:30 PM
pls mail the ppt to jamesjerin09[at]gmail.com
hope you will do the needfull
|
design and fabrication of geneva conveyor
|
pls mail the ppt to jamesjerin09[at]gmail.com
hope you will do the needfull
06-03-2016, 10:22 PM
06-03-2016, 10:29 PM
07-03-2016, 09:26 AM
design and fabrication of geneva conveyor
The Geneva mechanism is a timing device. According to Vector Mechanics for Engineers for Ferdinand P. Beer and E. Russell Johnston Jr., says, “ [It] is used in many counting instruments and in other applications where an intermittent rotary motion is required.” (945) Essentially, the Geneva mechanism consists of a rotating disk with a pin and another rotating disk with slots (usually four) into which the pin slides (see right).
According to Brittanica.com, the Geneva mechanism was originally invented by a watch maker. The watch maker only put a limited number of slots in one of the rotating disks so that the system could only go through so many rotations. This prevented the spring on the watch from being wound too tight, thus giving the mechanism its other name, the Geneva Stop. The Geneva Stop was incorporated into many of the first film projectors used in theaters.
In Optimum Design of Mechanical Elements, Ray C. Johnson makes many references to the use of the Geneva mechanism to provide an intermittent motion the conveyor belt of a "film recording marching." (13) He also discusses several weak points in the Geneva mechanism. For instance, for each rotation of the Geneva (slotted) gear the drive shaft must make one complete rotation. Thus for very high speeds, the drive shaft may start to vibrate. Another problem is wear, which is centralized at the drive pin. Finally, the designer has no control over the acceleration the Geneva mechanism will produce.
The Geneva mechanism is a timing device. According to Vector Mechanics for Engineers for Ferdinand P. Beer and E. Russell Johnston Jr., says, “ [It] is used in many counting instruments and in other applications where an intermittent rotary motion is required.” (945) Essentially, the Geneva mechanism consists of a rotating disk with a pin and another rotating disk with slots (usually four) into which the pin slides (see right).
According to Brittanica.com, the Geneva mechanism was originally invented by a watch maker. The watch maker only put a limited number of slots in one of the rotating disks so that the system could only go through so many rotations. This prevented the spring on the watch from being wound too tight, thus giving the mechanism its other name, the Geneva Stop. The Geneva Stop was incorporated into many of the first film projectors used in theaters.
In Optimum Design of Mechanical Elements, Ray C. Johnson makes many references to the use of the Geneva mechanism to provide an intermittent motion the conveyor belt of a "film recording marching." (13) He also discusses several weak points in the Geneva mechanism. For instance, for each rotation of the Geneva (slotted) gear the drive shaft must make one complete rotation. Thus for very high speeds, the drive shaft may start to vibrate. Another problem is wear, which is centralized at the drive pin. Finally, the designer has no control over the acceleration the Geneva mechanism will produce.
18-03-2016, 04:34 PM
hi Ashir to get details on fabrication of geneva conveyor please visit following lins where the details added .. if you want more info please reply there /..
http://studentbank.in/report-design-and-...yor?page=2
http://studentbank.in/report-design-and-...g-conveyor
http://studentbank.in/report-design-and-...yor?page=2
http://studentbank.in/report-design-and-...g-conveyor
|
« Next Oldest | Next Newest »
|
Important Note..!
If you are not satisfied with above reply ,..PleaseASK HERE
So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page| Tagged Pages: geneva fabricating design project, geneva mechanisms using conveyor in abstract pdf download, |
