difference between chopper fed drives and converter fed drives pdf ....etc

[:=Read Full Message Here=:]

Submitted By
R.PRASHANTH M.PRATHYUSH
K.PRAVEEN KUMAR
B.RADHIKA


ABSTRACT
Due to efficient control methods, DC motors are widely used motors to drive the loads in industry. Among the different control techniques for the DC motor speed control, armature voltage control method using Pulse Width Modulation (PWM) technique is the best one. We can realize the PWM control method u ....etc

[:=Read Full Message Here=:]

ECE 8830 - Electric Drives
Introduction
Current-fed inverters requires a “stiff” constant current source input - thus are sometimes referred to as CSI (current source inverters or current stiff inverters).

A large inductance can be used to change a variable voltage input to a variable current input.

VSI-inverters and CSI-inverters are dual to each other.
Introduction (cont’d)
Power semiconductor devices used in CSI inverters must be able to withstand large reverse voltag ....etc

[:=Read Full Message Here=:]

Abstract
A new zero-voltage-switching (ZVS) control approachis presented for pulsewidth modulation (PWM) buck convertersunder discontinuous conduction mode (DCM)/continuousconduction mode (CCM) boundary. This proposed technique compensatesfor control circuit delay, and hence, turns on power MOSat the instant exactly when drain-to-source voltage becomes zero.No complicated timing calculation circuits or additional externalcomponents are required. This proposed integrated ZVS controlcan be applied to other dc–dc converters as well. The ....etc

[:=Read Full Message Here=:]

Implementation of Full-Bridge Current-Fed Resonant Boost Converter using PIC microcontroller
ABSTRACT
This paper presents a current-fed full-bridge boost DC-ACDCconverter with transformer isolation operating withoutswitching power dissipation. The output voltage is regulatedby dc-ac converter whose frequency changes with a constantturn-off time of transistors. The proposed converter is devoidof parasitic oscillations, as all of the parasitic capacitancesand inductances are included in a resonant tank circuit. Themain advantage of such ....etc

[:=Read Full Message Here=:]

AIM:

Aim Of the Project Is Get the Energy From non conventional Energy Source To Convert 400v 3phase Energy. Using 3phase Zv ZC Switching Dc-Dc Convert For Fuel Cell Application.

ABSTRACT:
In spite of having many advantages, such as low
switch voltage and easy implementation, the voltage-fed dc–dc
converter has been suffering from problems associated with large transformer leakage inductance due to high transformer turn ratio when it is applied to low-voltage, ....etc

[:=Read Full Message Here=:]

i need full info about this topic ....etc

[:=Read Full Message Here=:]

A High Input Voltage Three-Phase ZVZCS DC-DC Converter with Vin /3 Voltage Stress on Primary Switches
Abstract
A high-voltage three-phase ZVZCS dc-dc converterwith low voltage stress is presented in this paper. The voltagestress on the primary switches is only one-third of the inputvoltage. By using the phase shift pulsewidth modulation (PWM)and secondary snubber, four of the six primary switches areoperating with zero-voltage switching (ZVS) and two of them areoperating with zero-current switching (ZCS), in order to reducethe switch ....etc

[:=Read Full Message Here=:]

Current-Fed Resonant Full-Bridge Boost DC/AC/DC Converter
INDIRECT dc/ac/dc converters utilizing an isolation transformer
are widely used in different applications, such as
battery chargers and dischargers, uninterruptible power systems,
alternative energy systems, hybrid electric vehicles, and
medical X-ray imaging.
In the case of the applications where low input voltages have
to be converted to high output voltages, current-fed converters
are used, whereas in the case of higher power applications, fullbridge
boost conv ....etc

[:=Read Full Message Here=:]

Difference between the chopper fed and converter fed drives ....etc

[:=Read Full Message Here=:]