ZERO VOLTAGE SWITCH


A zero voltage switch (ZVS) DC link, single-phase, pulse width-modulated
voltage source inverter (VSI) is proposed. Operating principle and various operating
intervals of the converter are presented and analyzed. Design consideration is
discussed and a design example of experimental results from a laboratory model is
also presented.
In proposed ZVS DC page link technique, the switch voltage is clamped to the dc
link voltage and PWM scheme can be used to contr ....etc

[:=Read Full Message Here=:]

this project is intended to make a circuit for detect when the motor shaft comes to a halt,here a small contactor attached to the shaft of the motor. As the motor rotates this contactor touches two pins A and B there by giving pulse to the comparator through a trigger circuit. As soon as the connection is established the output of the comparator changes and remains at that state for some time say for 0.25 seconds, before the output can change back, the contactor touches the pins again and again triggers the comparator. This continues as long a ....etc

[:=Read Full Message Here=:]

Abstract
A new zero-voltage-switching (ZVS) control approachis presented for pulsewidth modulation (PWM) buck convertersunder discontinuous conduction mode (DCM)/continuousconduction mode (CCM) boundary. This proposed technique compensatesfor control circuit delay, and hence, turns on power MOSat the instant exactly when drain-to-source voltage becomes zero.No complicated timing calculation circuits or additional externalcomponents are required. This proposed integrated ZVS controlcan be applied to other dc–dc converters as well. The ....etc

[:=Read Full Message Here=:]

Your Ad Here

i want full report on carbon chip or diamond chip
i want full report on carbon chip or diamond chip and ppt ....etc

[:=Read Full Message Here=:]

In the development of packaging of electronics the aim is to lower cost, increase the packaging density, and improve the performance while still maintaining or even improving the reliability of the circuits. Flip chip microelectronic assembly is the direct electrical connection of face-down electronic components onto substrates, circuit boards, or carriers, by means of conductive bumps on the chip bond pads since the chip is directly attached to the substrate, board, or carrier by the conductive bumps. Flip chip has advantage in size, performan ....etc

[:=Read Full Message Here=:]

A High Input Voltage Three-Phase ZVZCS DC-DC Converter with Vin /3 Voltage Stress on Primary Switches
Abstract
A high-voltage three-phase ZVZCS dc-dc converterwith low voltage stress is presented in this paper. The voltagestress on the primary switches is only one-third of the inputvoltage. By using the phase shift pulsewidth modulation (PWM)and secondary snubber, four of the six primary switches areoperating with zero-voltage switching (ZVS) and two of them areoperating with zero-current switching (ZCS), in order to reducethe switch ....etc

[:=Read Full Message Here=:]

i want to know the circuit diagram for zero voltage switching resonant dc page link inverter using auxilary boost converter and also the logic to turn on the switches.please help me finding the solution ....etc

[:=Read Full Message Here=:]

Electronics without silicon is unbelievable, but it will come true with the evolution of Diamond or Carbon chip. Now a day we are using silicon for the manufacturing of Electronic Chip's. It has many disadvantages when it is used in power electronic applications, such as bulk in size, slow operating speed etc. Carbon, Silicon and Germanium are belonging to the same group in the periodic table. They have four valance electrons in their outer shell. Pure Silicon and Germanium are semiconductors in normal temperature. So in the earlier days they a ....etc

[:=Read Full Message Here=:]

Introduction
The zero-cross family of optically isolated triac drivers is an inexpensive, simple and effective solution for interface applications between low current dc control circuits such as logic gates and microprocessors and ac power loads (120, 240 or 380 volt, single or 3-phase). These devices provide sufficient gate trigger current for high current, high voltage thyristors, while providing a guaranteed 7.5 kV dielectric withstand voltage between the line and the control circultry. An integrated, ze ....etc

[:=Read Full Message Here=:]

AIM:

Aim Of the Project Is Get the Energy From non conventional Energy Source To Convert 400v 3phase Energy. Using 3phase Zv ZC Switching Dc-Dc Convert For Fuel Cell Application.

ABSTRACT:
In spite of having many advantages, such as low
switch voltage and easy implementation, the voltage-fed dc–dc
converter has been suffering from problems associated with large transformer leakage inductance due to high transformer turn ratio when it is applied to low-voltage, ....etc

[:=Read Full Message Here=:]