ANALYSIS OF RESIDUAL STRESSES IN MAIN CRANKSHAFT BEARINGS AFTER INDUCTION SURFACE HARDENING AND FINISH GRINDING


INDUCTION SURFACE HARDENING

ADVANTAGES

¢ Short Heat Treatment Times

¢ Good Repeatability

¢ Hardened Layer Quality

¢ Small or Negligible Subsequent Distortion

¢ Minimum Subsequent Product Surface Oxidation

¢ Good Possibilities for Automation

SURFACE INTEGRITY AND ITS LEVELS

Scientific discipline providing an integral assessment of the surface and surface layers
Measurement of Roughness ....etc

[:=Read Full Message Here=:]

Abstract:
This paper deals with the direct torque control of capacitor multilevel VSI actuators. The active control strategy high voltage I high power induction motors fed by floating egy for well-balancing the capacitor voltages is presented highlighting an optimal pattern. The efficiency of this approach is compared to the well-known passive method and it is illustrated by simulation. In the next section, a controlled cycle based algorithm is proposed as an attractive solution for a high performance torque control ....etc

[:=Read Full Message Here=:]

Abstract
Efficiency and scalability are fundamental issues concerning data mining in large databases. Although classification has been studied extensively, few of the known methods take serious consideration of efficient induction in large databases and the analysis of data at multiple abstraction levels. The paper addresses the efficiency and scalability issues by proposing a data classification method which integrates attribute oriented induction, relevance analysis, and the induction of decision trees. Such an integration leads to efficient ....etc

[:=Read Full Message Here=:]

ENHANCED PERFORMANCE OF A DOUBLY FED
WIND-POWER INDUCTION GENERATOR AT WIND-
RANGE BOUNDARIES
ABSTRACT
The doubly fed induction generator (DFIG) is one of the largest generators used
with MW-class wind turbines. This paper focuses on the weak performance areas
of grid-connected DFIG-based wind turbines. Basically, the DFIG performance at
low wind speeds, close to the cut in speed, and around the full rating operation (in
the vicinity of rated wind speed) is investigated. For low wind speed region, the
c ....etc

[:=Read Full Message Here=:]

In this seminar the cadmium™s effect on anti-oxidative enzymes in tomato (Lycopersicon esculentum) plants was evaluated. Plants treated with increasingly CdCl2concentrations (0, 20, 40, 80, 100 and 200 M respectively) were grown in a basic nutrient solution for 7 days. APX (Ascorbate Peroxidase) and GPX (Guaïgol Peroxidase) activities showed to increase below 100 M concentration after treatment. In excessive concentration however, more than determined level, a significant decrease in the enzymes activities was determined. The incr ....etc

[:=Read Full Message Here=:]

INTRODUCTION
Man is an ambitious creator. He has conquered the world of science and has reached to this 21ST century. In pre-cuts of perfection. He has cared much for automation and product quality which is directly co related to electronics.
In this fact developing society, electronic has come to stay as the most important branch of Engineering. Electronic devices are being used in almost all the industries for quality control and automation. They have become a fast replacement of present workers army which is engage ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Incorporation of FACTS Controllers in Newton Raphson Load Flow for Power Flow Operation, Control and Planning: A Comprehensive Survey
Abstract-
This paper presents a comprehensive survey ofincorporation of FACTS controller such as SVC, TCSC,SSSC, STATCOM, UPFC, and IPFC devices in Newton-Raphson load flow (NRFL) for power flow control. Thepurpose of this paper is to present a comprehensive surveyof various FACTS controllers are incorporated in loadflow analysis for different point of view such as optimalpower flow control, planning an ....etc

[:=Read Full Message Here=:]

iadvance tumble flow induction technology is my seminar topic
plese give me material on this topic ....etc

[:=Read Full Message Here=:]

Usefulness of DC Power Flow for Active Power Flow Analysis



I. INTRODUCTION
STATIC power system analysis has always been
performed using full power flow. It is one of the
fundamental tools for power system analysis and is used in
the operational as well as planning stages. Vertically
integrated companies have used it to control their systems, as
well as to plan the optimal economic operation of generation
resources, either by means of optimal power flo ....etc

[:=Read Full Message Here=:]