The ignition system of a vehicle typically consists of the key cylinder as well as a key which is kept in such a way that it can allow the vehicle to remain in the running state even when the key is removed. A timer is set in such a way that the time delay from leaving the engine running should be less than a threshold value. In the second set of security check, the engine is shut down when the vehicle fails to meet the second set of security conditions.

Hardware used:
AT command supporting mobile phone
microcontroller
relays and relay d ....etc

[:=Read Full Message Here=:]

LABORATORY INVESTIGATION OF LOW SWIRL INJECTOR FOR LEAN PRE-MIXED GAS TURBINES


SEMINAR REPORT Submitted by
KIRAN .G.
S7M2
ROLL NO-30
Department Of Mechanical Engineering
College of Engineering, Thiruvananthapuram – 16
OCTOBER 2010




ABSTRACT

Laboratory experiments have been conducted to investigate the fuel effects on the

turbulent premixed flames produced by a gas turbine low-swirl injector (LSI). The

lean-blow off li ....etc

[:=Read Full Message Here=:]

SMS based vehicle Ignition controlling system ....etc

[:=Read Full Message Here=:]

ABSTRACT
As the demand for higher engine efficiencies and lower emissions drive stationary, spark-ignited reciprocating engine combustion to leaner air/fuel operating conditions and higher in-cylinder pressures, increased spark energy is required for maintain stable combustion and low emissions. Unfortunately, increased spark energy negatively impacts spark plug durability and its effectiveness in transmitting adequate energy as an ignition source. Laser ignition offers the potential to improve ignition system durability, reduce ma ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

send working principle and power point presentation on this topic ....etc

[:=Read Full Message Here=:]

Usefulness of DC Power Flow for Active Power Flow Analysis



I. INTRODUCTION
STATIC power system analysis has always been
performed using full power flow. It is one of the
fundamental tools for power system analysis and is used in
the operational as well as planning stages. Vertically
integrated companies have used it to control their systems, as
well as to plan the optimal economic operation of generation
resources, either by means of optimal power flo ....etc

[:=Read Full Message Here=:]

can you detail report on this project idea. so that i can submit this project in my college. ....etc

[:=Read Full Message Here=:]

ppt of transonic engine new injection system no ignition system ppt ....etc

[:=Read Full Message Here=:]

Incorporation of FACTS Controllers in Newton Raphson Load Flow for Power Flow Operation, Control and Planning: A Comprehensive Survey
Abstract-
This paper presents a comprehensive survey ofincorporation of FACTS controller such as SVC, TCSC,SSSC, STATCOM, UPFC, and IPFC devices in Newton-Raphson load flow (NRFL) for power flow control. Thepurpose of this paper is to present a comprehensive surveyof various FACTS controllers are incorporated in loadflow analysis for different point of view such as optimalpower flow control, planning an ....etc

[:=Read Full Message Here=:]