silicon control rectifier -scr

Content

Introduction
What is SCR ?
Characteristic of SCR
Two transistor analog connection
Series connection of SCR
Parallel connection of SCR
Advantages
Disadvantages
Conclusion

....etc

[:=Read Full Message Here=:]

1. Current injection in a controlled rectifier under unbalanced supply and variable line and load inductances
2. The Single-Phase Single-Switch PWM Three-Level High Power Factor Rectifier for DC Network Application
3. Design and performance of a transformer less shunt hybrid filter integrated into a three-phase diode rectifier-paper not searching
4. A Bridgeless PFC Boost Rectifier With Optimized Magnetic Utilization
5. Design of High Power Density DC Bus Converter Based on LLC Resonant Converter with Synchronous Rectifier
6. Constant freq ....etc

[:=Read Full Message Here=:]

Abstract
This work describes a novel method in improving the
input current total harmonic distortion (THD) as well as the power
factor of a three-phase suppressed-link rectifier-inverter circuit.
This proposed method makes use of only three bi-directional low
power static switches with a relatively simple gating circuit. This
paper illustrates how the proposed method is superior in reducing
the input current THD of a rectifier-inverter set to about 5%,
which is in line with the requirements of IEEE standard 519–1992.
This is a ....etc

[:=Read Full Message Here=:]

give me compounding and regulation notes ....etc

[:=Read Full Message Here=:]

3-Phase Power Factor Correction, Using Vienna Rectifier Approach and Modular Construction for Improved Overall Performance, Efficiency and Reliability
1.0 Abstract:
While applications for 1-Phase PFC are now familiar and prevalent, the same is not the
case with 3-Phase PFC. Many equipments using kilowatts of power from 3-Phase mains
should be candidates of 3-Phase power factor correction, because several advantages
ensue, both to the user of the equipment and to the utility. The Vienna Rectifier approach
to achieve 3-Phase ....etc

[:=Read Full Message Here=:]

Presented By:
Rahul Ranjan
Rahul Srivastava
Ravi Shankar Patel
Rishu Raj Singh
Shashi Bhushan


AUTOMATIC POWER FACTOR CONTROLLER CUM RECTIFIER
Project Aim
This project discusses the need for power factor correction and provided a suitable do-it-yourself (DIY) solution that could be used for small-scale industries and establishments.
In small industrial units where the load is contributed by a number of inductive appliances, it is cumbersome to switch in capacitor banks at the power entry poin ....etc

[:=Read Full Message Here=:]

Inverter compounding- uncompounded inverter- rectifier compounding- transmission characteristics with the rectifier and inverter compounding-
current regulation from the inverter side.

sir/mam,
i need the notes for the above topics with respect to HVDC transmission,
i searched for it, but i didn't get any information from the internet, so please guide me for my exams.....
It ll be more be useful if i get the response at the earliest posible time, as i have to prepare for my exam tomorrow

my mail id: [email protected]

than ....etc

[:=Read Full Message Here=:]

INTRODUCTION
Efficient control of D.C motor speed is very economical to any industries for that reason we are using full wave rectifier in which we are using triacs as switches because of bi-directional nature of triacs we are preferred instead of using thyrister as a switches. To obtain a four quadrant operation we need 8 switches if we use thyristers (this circuit called dual converter) and if we use triacs we need 4 switches only.
....etc

[:=Read Full Message Here=:]

what are the requirements,procedure,calculations and result of setting up a transistor circuit and to study its input and output charecteristics. ....etc

[:=Read Full Message Here=:]

Abstract
An active current injection network for a three-phaserectifier is proposed. The proposed circuit uses three bidirectionalswitches operating at low frequency and a half-bridge inverteroperating at high frequency. It also uses an inductor in orderto make the current modulation. Because only 3.7% of the totalpower delivered to the load is processed by the injection network,the proposed converter offers high efficiency, and not only a highpower factor is obtained but also the total harmonic distortion isreduced. Operation, analysi ....etc

[:=Read Full Message Here=:]