hello,i m ASAD ali from i m electrical engineering final year student and i m intrusted in transformer so i want to go for some good project about trasnformer
so please send me information about measurement of inrush current in transformer and how can i use it for the protection of distribution transformer by designing some relay or some thing else please give me good idea and tell me how i should start my project i hope i ll get good and very usefull guide line from you sir.

....etc

[:=Read Full Message Here=:]

ABSTRACT
Time and again the Formula 1 world has proved that the safest place on earth is inside an F1 car. The number one cause of racing related fatalities was the basilar skull fractures from excessive head motions and neck loading. With the introduction of the new Head And Neck Support (HANS) the drivers were able to overcome the only window for injury.
The fundamental purpose of the system is to effectively form a single Ëœbodyâ„¢ of the head and torso. HANS is intended to prevent driverâ„¢s head from being thr ....etc

[:=Read Full Message Here=:]

i need the basic ckt daigram of the prjct so that it can b easily implemented practically......also the theoritical knowledge of the project... ....etc

[:=Read Full Message Here=:]

how to setup rediffmailpro settings for blackberry curve 9220? ....etc

[:=Read Full Message Here=:]

Definition

An accurate electric current transducer is a key component of any power system instrumentation. To measure currents power stations and substations conventionally employ inductive type current transformers with core and windings. For high voltage applications, porcelain insulators and oil-impregnated materials have to be used to produce insulation between the primary bus and the secondary windings. The insulation structure has to be designed carefully to avoid electric field stresses, which could eventually cause insulation breakdo ....etc

[:=Read Full Message Here=:]

plz send me pdf file for above subject ....etc

[:=Read Full Message Here=:]

ppt for industrial high voltage transformer protection against overheating of transformer using microcontroller
please help me ....etc

[:=Read Full Message Here=:]

1. Abstract
The second harmonic inrush restraint function of transformerdifferential relays maintains security of the differential protectionduring transformer inrush events. The typical setpoint for thesecond harmonic restraint is the relay manufacturer’s defaultor recommended setting of 20% of fundamental current, withsome adjustment based on operating experience. However,some operating situations may result in levels of secondharmonic current lower than 20% during inrush, and levels maybe as low as 5%. This lower level of second h ....etc

[:=Read Full Message Here=:]

How to use a mains transformer (for instance 110-230 Volt and 50-60 Hz) in an electronic project. Do's and dont's with mains transformers in home brew electronics.

Saturation of the core means that the core gets more or less permanenty magnetised. In that case the magnetic field is not built up (and decreased) quickly enough (50 Hz -60 Hz), the permanent field acts as a sort of brake for quick magnetic changes and the power cannot be well transferred from the primary to the secundary coil. The core gets heated up more or less, it gives lo ....etc

[:=Read Full Message Here=:]

Magneto-optical current transformer technology (MOCT)

An accurate electric current transducer is a key component of any power system instrumentation. To measure currents power stations and substations conventionally employ inductive type current transformers with core and windings. For high voltage applications, porcelain insulators and oil-impregnated materials have to be used to produce insulation between the primary bus and the secondary windings. The insulation structure has to be designed car ....etc

[:=Read Full Message Here=:]