Computerized Conveyor Belt Control
A belt conveyor consists of two or more pulleys, with a continuous loop of material - the conveyor belt - that rotates about them. One or both of the pulleys are powered, moving the belt and the material on the belt forward. The powered pulley is called the drive pulley while the un-powered pulley is called the idler. There are two main industrial classes of belt conveyors; those in general material handling such as those moving boxes along inside a factory and bulk material handlin ....etc

[:=Read Full Message Here=:]

TYPES OF BELT DRIVES AND THEIR POWER TRANSMISSION CAPACITY ....etc

[:=Read Full Message Here=:]

1. Abstract
The second harmonic inrush restraint function of transformerdifferential relays maintains security of the differential protectionduring transformer inrush events. The typical setpoint for thesecond harmonic restraint is the relay manufacturer’s defaultor recommended setting of 20% of fundamental current, withsome adjustment based on operating experience. However,some operating situations may result in levels of secondharmonic current lower than 20% during inrush, and levels maybe as low as 5%. This lower level of second h ....etc

[:=Read Full Message Here=:]

From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives: influence
Abstract —
Serpentine belt drives are often used in front
end accessory drive of automotive engine. The accessories
resistant torques are getting higher within new technological
innovations as stater-alternator, and belt transmissions
are always asked for higher capacity. Two kind of tensioners
are used to maintain minimum tension that insure power
transmission and minimize slip: dry friction or hydraulic
tensioners. An ....etc

[:=Read Full Message Here=:]

Abstract

A belt is a looped strip of flexible material, used to mechanically page link two or more rotating shafts.
They may be used as a source of motion, to efficiently transmit power, or to track relative movement. Belts are looped over pulleys.
In a two pulley system, the belt can either drive the pulleys in the same direction, or the belt may be crossed, so that the direction of the shafts is opposite.

For more information, please visit
http://srmuniv.acdownloads/belt_drive.ppt
....etc

[:=Read Full Message Here=:]

Prepared by:
MUHAMMAD NASIRUDDIN MAHYUDDIN


Introduction

The first step is to determine tha control. The purpose of the control law is to allow us to assign a set of pole locations for the closed-loop system that will correspond to satisfactory dynamic response in terms of rise time and other measure of transient response.
Then, secondly, we show how to introduce the reference input with full-state feedback. We describe the process of finding the poles for good design. In the second step, If t ....etc

[:=Read Full Message Here=:]

ABSTRACT
Time and again the Formula 1 world has proved that the safest place on earth is inside an F1 car. The number one cause of racing related fatalities was the basilar skull fractures from excessive head motions and neck loading. With the introduction of the new Head And Neck Support (HANS) the drivers were able to overcome the only window for injury.
The fundamental purpose of the system is to effectively form a single Ëœbodyâ„¢ of the head and torso. HANS is intended to prevent driverâ„¢s head from being thr ....etc

[:=Read Full Message Here=:]

STEPPER MOTOR CONTROL WITH SELECTED STEPS FOR CONVEYOR
BELT. ....etc

[:=Read Full Message Here=:]

send me the my email is [email protected] ....etc

[:=Read Full Message Here=:]

Introduction

-Conveyor belts are used in many industries to transport goods and materials between stages of a process.
-Conveyor systems is a good way to reduce the risks of musculoskeletal injury in tasks or processes that involve manual handling.
-If they are not properly designed conveyor belt workstations can contribute to the development of musculoskeletal disorders (MSD’s).
-MSD’s can develop when workers adopt awkward and uncomfortable postures for long periods while working.
-Leaning, stoopin ....etc

[:=Read Full Message Here=:]