design , experimentation and investigation of composite propeller shaft used aerospace industries using ansys and autocad software ....etc

[:=Read Full Message Here=:]

Authors:
samir Mohamed El-Makkawy
Abstract:
Partial discharge (P.D.) in micro cavities in the insulation of H.V. power cables drastically affect the performance, the field distribution and hence the rating of these cables. It is well known that, P.D. deteriorates power cables and lead to its complete failure. This has adverse effects on the reliability and maintainability of power supply, which affects directly the production of industrial factories. In this work a study and investigation of the effect of partial discharges in cavit ....etc

[:=Read Full Message Here=:]

LABORATORY INVESTIGATION OF LOW SWIRL INJECTOR FOR LEAN PRE-MIXED GAS TURBINES


SEMINAR REPORT Submitted by
KIRAN .G.
S7M2
ROLL NO-30
Department Of Mechanical Engineering
College of Engineering, Thiruvananthapuram – 16
OCTOBER 2010




ABSTRACT

Laboratory experiments have been conducted to investigate the fuel effects on the

turbulent premixed flames produced by a gas turbine low-swirl injector (LSI). The

lean-blow off li ....etc

[:=Read Full Message Here=:]

Cost effective and reliable damage detection is critical for the utilization of thin layered materials and microstructures.This Thesis presents a brief overview of conventional NDT methods and the usage of unconventional NDT methods applicable to thin layered materials, and the conclusion of applicability of these methods for damage detection in thin layered materials

http://projectsparadisedefects-thin-layered-materials/# ....etc

[:=Read Full Message Here=:]

Development and Investigation of Solar Cooling Systems Based on small-Scale Sorption Heat Pumps
Abstract
This paper presents the development and investigation of solar cooling systems based on
small-scale sorption heat pumps and chillers, respectively. An ammonia/water absorption
chiller with a cooling capacity of 12 kW, the chillii® PSC12, a 17.5 kW water/lithium
bromide absorber, the chillii® WFC18 and two water/silica-gel adsorption chillers with
cooling capacities of 7.5 and 15 kW, the chillii ....etc

[:=Read Full Message Here=:]

presented by:
J.Chaithanya Bharathi
A.L.Harika
P.Divya Sree


Aim of the Project
To investigate the effects on the alternators when subjected to various types of loads and to minimize obtained harmonics
Overview
Project Objectives
 To determine various parameters under different loading conditions for:
• Laminated rotor alternator
• Solid rotor alternator
Parallel-connected alternators
 To analyze the voltage regulations under these conditions
 To analyze th ....etc

[:=Read Full Message Here=:]

research topics in digital image processing ....etc

[:=Read Full Message Here=:]

This article is presented by:
xxxxSlim Rekhis and Noureddine Boudriga
Communication Networks and Security Research Lab. University of the 7th November at Carthage, Tunisia.xxxxxxxxxx

Formal Digital Investigation of Anti-forensic Attacks


ABSTRACT
One of the major interest perceived by research in digital forensic investigation is the development of theoretical and scientifically proven methods of incident analysis. However, two mai ....etc

[:=Read Full Message Here=:]

what is the impact factor of archives of physics research? ....etc

[:=Read Full Message Here=:]

By,
PRADEEP.T.P

Introduction

Copper , Aluminium and Lead-common journal bearing materials.
Bronze and Brass- Copper based alloys.
Zamacs - Zinc based alloys.
Duralumines - Aluminium based alloys.
White metals- Tin lead based alloys.
Present study- Tribological and mechanical properties of these journal bearings materials.

Tribology

Science and technology of interacting surfaces in relative motion and of related sub and practices.
Deals with ....etc

[:=Read Full Message Here=:]