LABORATORY INVESTIGATION OF LOW SWIRL INJECTOR FOR LEAN PRE-MIXED GAS TURBINES


SEMINAR REPORT Submitted by
KIRAN .G.
S7M2
ROLL NO-30
Department Of Mechanical Engineering
College of Engineering, Thiruvananthapuram – 16
OCTOBER 2010




ABSTRACT

Laboratory experiments have been conducted to investigate the fuel effects on the

turbulent premixed flames produced by a gas turbine low-swirl injector (LSI). The

lean-blow off li ....etc

[:=Read Full Message Here=:]

Hands-on Oriented Curriculum and Laboratory Development for Embedded System Design
Abstract
As embedded systems are getting popular in industrial prod- uct designs, a dedicated teaching laboratory for embedded systems (EST Lab) has been setup for college and graduate students to get familiar with embedded system engineering and researches. In this paper, we present our experiences in embedded system education curriculum and teaching labo- ratory design carried out in the past few years. Accompa- nied by a series of ....etc

[:=Read Full Message Here=:]

Prepared by:
Neha Gupta

INTRODUCTION

-Laboratory:
Room or Building that is used for scientific work.
-Engineering education necessitates the use of laboratories for measurement, data collection, analysis and design activities as well as for hands on experience of equipment, physical devices and for empirical evaluation.
-Remote laboratories allow users to perform experiments and laboratory tasks over the Internet without being near the actual equipment.
....etc

[:=Read Full Message Here=:]

Hi, I am Vikram. I would like to download TLM for nanotechnology in  Gujarati language. I also would like to download Maths and Environmental science TLM in Gujarati if available. I shall be thankful if anybody can help me with the topics mentioned above. ....etc

[:=Read Full Message Here=:]

proposes an autonomous train control system based on inter-train communication. In this new system, there is no logical central device and trains can communicate with each other autonomously. The train itself produces the position and calculates the permitted track speed. Therefore, the distance between trains can be shortened and a smooth brake pattern can be obtained. For building this system without hindering the current system operations, the gateway-based replacement technology and its test methods are explained. The assurance of test meth ....etc

[:=Read Full Message Here=:]

1.The spacing between lines and paragraphs :
(A)Hyphenation(B)Leading(C )Indenting(D)None of these

2.Estimating the number of pages a manuscript would make when set in type is :
(A)Casting off(B)Casting in(C )Copy filting(D)Planning

3.One Pica =
(A)8 points(B)38 points(C )12 points(D)72 points

4.The arrangement of pages for printing to appear in proper order for folding is known as :
(A)Registration (B) Imposition (C ) Gathering (D) layout

5.The adjoining inner margins of two facing printed pages : 
(A) Poli ....etc

[:=Read Full Message Here=:]

149/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1. The Normal Glomerular filtration rate is :
(A) 2 ml/minute
(B)2 ml/sec
(C ) 2 litre/minute
(D)2 litre/sec

2.is the causative agent of syphilis.
(A) Salmonella typhi
(B)Streptococci
(C ) Treponema pallidum
(D)Sarcinia

3.A platelet diluting fluid :
(A) Rees — Ecker solution
(B)Hingle Mann’s fluid
(C ) Dunger’s fluid
(D)Hayem’s fluid

4.Bombay blood group can be detected by :
(A) Cell grouping
(B)Cross matching
(C ) Serum grouping
....etc

[:=Read Full Message Here=:]

Abstract - An integrated solution based on CAN protocol, for industrial measurements and control, is presented. Main characteristics of CAN protocol are underlined in terms of OSI model taking particular attention to hardware implementation, messages types, collision resolution mechanisms and timing synchronization. The paper also includes references to another high level industrial protocols that use the physical and logical data layers of CAN protocol. Experimental results based on a developed prototype applied to a level control loop system ....etc

[:=Read Full Message Here=:]

1.Processed data is called :
(A) Value(B)Information
(C ) Summary(D)Program

2.Scanner is a____________device.
(A) primary memory(B)output
(C ) input(D)secondary memory

3.Difference between compiler and interpreter is :
(A) Compiler checks the code as a whole and interpreter checks line by line of the code
(B) Interpreter checks the code as a whole and compiler checks line by line of the code
(C ) Compiler used to find syntax errors while interpreter used to find run time error
(D) Interpreter used to find syntax ....etc

[:=Read Full Message Here=:]

Please help me on topics noise pollution according to uttam EVS PROJECT BOOK ....etc

[:=Read Full Message Here=:]