INTRODUCTION
I Tâ„¢s Challenge
In the past three tears, the world has changed for information technology groups. In the late 1990s, the predominant problem was deploying equipment and software quickly enough to keep up with demand for computing. While the tech sector boomed on Wall Street, money was no object. IT budgets swelled and the numbers of computers in data centers grew exponentially.
Now, in the early 2000s, the picture is very different. IT budgets are flat down, yet business demand for IT services contin ....etc

[:=Read Full Message Here=:]

1._________________is provided on the road edge to serve as a emergency lane for vehicles compelled to taken out of the pavement.
(A)Kerb(B)Shoulder
(C )Carriage wayCarriage way(D)Gradient

2.The brick laid with its breadth parallel to the face of awall is known as :
(A)Stretcher bond(B)Zigzag bondZigzag bond
(C )Garden wall bond(D)Header bondHeader bond

3.Bearing pile is situated in :
(A)Hard stratum(B)Water
(C )Above ground levelAbove ground level(D)None of these

4.The camber provided for gravel road is :
(A) ....etc

[:=Read Full Message Here=:]

Abstract
An earthquake resistant high strength material has been sought. It was concluded that the interface layers of fibrous materials increased the compressive strength and a certain geometrical shape of these layer materials gave the best results. The mix proposed satis?es the minimum compressive strength requirements of ASTM and Turkish Standards.

The materials used in this study for ?bre reinforced mud brick production were clay as main matrix; cement, basaltic pumice, lime and gypsum as stabilisers; straw, plastic Fibres and ....etc

[:=Read Full Message Here=:]

1. A STUDY OF MUNICIPAL SOLID WASTE MANAGEMENT IN PUTTUR TOWN - DAKSHINA KANNADA

2. STUDY ON STRENGTH BEHAVIOUR OF CONCRETE USING FOUNDRY DUST IN FINE AGGREGATE

3. SUSTAINABLE AND COST EFFECTIVENESS BUILDING MATERIAL TECHNOLOGY THROUGH PARTIAL REPLACEMENT OF CEMENT BY GRANITE CUTTING SLURRY WASTE POWDER AND PARTIAL REPLACEMENT OF COARSE AGGRETATE BY MANGALORE TILES BATS FOR ARCH LINTELS

4. DESIGN AND EVALUATION OF HIGH VOLUME FLYASH CONCRETE FOR RIGID PAVEMENT OVERLAYS

5. ASSESSMENT OF WATER QUALITY INDEX FOR GROUND WATER - CASE STU ....etc

[:=Read Full Message Here=:]

105/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.The type of pointing in which the mortar is pressed in to the raked joints and finished off flush with the edges of the bricks or stone is called :
(A)Flush pointing
(B)Tuck pointing
(C )Stuck pointing
(D)V-grooved pointing

2.The pointing which is extensively used in brick work and stone masonry (on face) is :
(A)Stuck pointing
(B)Tuck pointing
(C )V-grooved pointing
(D)Flush pointing

3.The process of filling up all nail holes, cracks etc. with p ....etc

[:=Read Full Message Here=:]

I want to know procedure of brick bat coba waterproofing ....etc

[:=Read Full Message Here=:]

i want to get full seminar eport on compressed earth blocks for construction ....etc

[:=Read Full Message Here=:]

hi, i would like to setup a CLC brick plant with 1000 bricks per day capacity.i need loan for 10 lakhs.can you please provide me details about governement loans for CLC bricks. ....etc

[:=Read Full Message Here=:]

hai I want an example of seminar report on durability of brick masonry,please help ....etc

[:=Read Full Message Here=:]

029/2016
Maximum :
100 marks

Time : 1 hour and 15 minutes
l.Imaginary vertical line joining the arrisesis called:
(A) Lap
(B)Perpends
(C ) Bed
(D)Racking

2.Colour of Roman cement is :
(A) Ash
(B)Grey
(C ) Brown
(D)Black

3.Cupola furnace is used to produce :
(A) Pig iron
(B)Cast iron
(C ) Steel
(D)Wrought, iron

4.Uniform seasoning of timber is done by :
(A) Hot drying
(B)Humidity drying
(C ) Drying 
(D)Moist drying

5.Age of good trees for felling varies from :
(A) 20 to 35 years
(B)35 to ....etc

[:=Read Full Message Here=:]

hi i need abstract of mechanical manual brick making machine ....etc

[:=Read Full Message Here=:]

Presented By
Kazi Mahmudul Haque Bhadhon
Md. Tanvir Faisal


REFRACTORY BRICK INDUSTRY DESIGN
INTRODUCTION
Refractory Bricks are bricks that can withstand high temperature.
A block of refractory ceramic material.
Should not spall under rapid temperature change, and their strength should hold up well during rapid temperature changes.
Dense firebricks are used in applications with extreme mechanical, chemical, or thermal stresses.
In other, less harsh situations, more porous bricks are used.
....etc

[:=Read Full Message Here=:]

I want a ppt on bricks bonding .urgently needed ....etc

[:=Read Full Message Here=:]

CAVITY WALLS
INTRODUCTION
The term «cavity wall» is applied to a type of masonry wall construction in which a continuous air space or cavity is provided inside the wall.
A cavity wall therefore is actually two walls separated by an air space, but joined by means of metal ties for structural strength. They are extensively used in European countries, particularly Great Britain, where they have been developed as a means of obtaining protection from penetration of rain through masonry walls.
In recent y ....etc

[:=Read Full Message Here=:]

Fibre reinforced mud brick as a buiilding material seminar report ....etc

[:=Read Full Message Here=:]

plz give the details of slope in brick bat coba ....etc

[:=Read Full Message Here=:]

Presented By
Kazi Mahmudul Haque Bhadhon
Md. Tanvir Faisal


REFRACTORY BRICK INDUSTRY DESIGN
INTRODUCTION
Refractory Bricks are bricks that can withstand high temperature.
A block of refractory ceramic material.
Should not spall under rapid temperature change, and their strength should hold up well during rapid temperature changes.
Dense firebricks are used in applications with extreme mechanical, chemical, or thermal stresses.
In other, less harsh situations, more porous bricks are used.
....etc

[:=Read Full Message Here=:]

53/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.The whole circle bearing of a line is 283° 20', its corresponding quadrantal bearing is :
(A)N 77° 20'E
(B) N 76° 20' W
(C ) S 76° 40' E
(D) N 76° 40' W

2.During the measurement, variable tension in tape results--------error.
(A)Cumulative
(B) Compensative
(C ) Instrumental
(D) None of the above

3.The Gunters chain is---------------ft. long and its link length is---------ft.
(A)66 ft long and 0.66 ft ,
(B)33 ft long and .33 ft
(C )33 ft lo ....etc

[:=Read Full Message Here=:]

to get report/presentation and design details of each project topic please browse through this page http://studentbank.in/topic-mechanical-engineering-project-ideas

1. AUTO DRAIN VALVE WITH AIR DRIER FOR COMPRESSOR
2. AUTO HAMMER STRIKER
3. AUTO SIDE STAND INDICATOR AND CENTER STAND
4. AUTOMATIC LUBRICATING MACHINE
5. AUTOMATIC DIMENSIONING MACHINE
6. AUTOMATIC DISC PARKING SYSTEM
7. WIND MILL PROJECT
8. WIND MILL WATER PUMP
9. AUTOMATIC DRILLING AND TAPPING MACHINE
10. AUTOMATIC GEAR CHANGER
11. ....etc

[:=Read Full Message Here=:]