104/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.The Poisson’s ratio of a material is 0.4. If a force is applied to this material, there is a decrease in cross sectional area by 2%. The percentage increase in its length is :
(A) 0.25%
(B)0.5%
(C ) 2.5%
(D)3%

2.The difference between LST and EST is called :•
(A) Activity
(B)Event
(C ) Float
(D)Critical path

3.Identify the method which is not a LPP technique :•
(A) Graphical method
(B)Transportation problem
(C ) Simplex method
(D)ABC an ....etc

[:=Read Full Message Here=:]

195/2015
1.Granite is an example of__________type of rocks.
(A)Igneous rocks
(B)Sedimentary rocks
(C )Metamorphic rocks
(D)None of these

2.The main reason for using stones in building works is its :
(A)Good appearance
(B)Resistance to fire
(C )I ow water absorption
(D)Durability

3.In the manufacture of bricks, a pug mill is used for ;
(A)Proportioning ofingredients
(B)Tempering
(C )Blending
(D)Digging

4.The initial setting time of ordinary cement should be less than :
(A)10 minutes 
(B)1 hour
(C )1 ....etc

[:=Read Full Message Here=:]

210/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1. The main reinforcement in a simply supported RCC member placed at:
(A) Top fibre
(B)Side fibre
(C ) Bottom fibre
(D)None of these

2.If the load at the free end cantilever beam is increased the failure will occur at
(A) Free end
(B)Centre
(C ) Support
(D)None of the above

3.Chemically, marble is known as :
(A) Siliceous rock
(B)Metamorphic rock
(C ) Argillaceous rock
(D)Calcareous rock

4.Brick lintels are used when the span is :
(A) Less ....etc

[:=Read Full Message Here=:]

1. Which of the following is used in ceiling fan?
(A) Universal motor(B)Synchronous motorSynchronous motor
(C ) Series motor(D)Induction motorInduction motor

2.Active power in 3 phase circuit is :
(A) -»/3 VLILcosfφ (B)3 VLIL cosφ 3 VLIL cosφ 
(C ) V3 VrhIrhco8φ (D)•/a vh. V sinφ 

3.Unit of luminous intensity :
(A) Lumen(B)LuxLux
(C ) Lumen/m2(D)CandelaCandela

4.The power factor of pure resistive circuit is :
(A) Zero(B)LeadingLeading
(C ) Lagging(D)UnityUnity

5.Illumination of a surface is inv ....etc

[:=Read Full Message Here=:]

1.Concurrent forces are those forces whose line of action?
(A)Meet at one point (B) Lie on the same line
(C ) Meet on the same plane (D) None of these

2.The angle between two forces when the resultant maximum and 

minimum respectively are?
((A)0° and 180c (B) 180° and 360°
(C ) 90° and 180° (D) 90° and 360°

3.When the spring of a watch is wound, it will posses
(A)Strain (B)Kinetic energy
(C ) Heat energy (D)Electrical energy

4.The moment of inertia of a rectangular section 3 cm wide and 4 

cm d ....etc

[:=Read Full Message Here=:]

102/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1. The international nautical mile is same as :
(A)18.52 Km/hr
(B)1.609 Km/hr
(C ) 1.852 Km/hr
(D)16.09 Km/hr

2.The true weight of a granular material is its :
(A)Specific Gravity x Weight of Water
(C ) Density x Volume
(B) mxa
(D) Mass / volume

3.The Property of a solid to sustain shock load without permanent deformation 
(A)Tenacity
(B) Quenching
(C ) Milling
(D) Resilience

4.The pH value of strong caustic soda is about:
(A)7
(B) 13
(C ....etc

[:=Read Full Message Here=:]

1.1 volt is equal to :
(A)One coulomb per second
(B)One joule per coulomb
(C )One coulomb per joule
(D)Work done is transfering a charge of one coulomb

2.Theresistance of a conductor increases as its:
(A)Gross sectional area decreases
(B)Length decreases
(C )Resistivity decreases
(D)length is reduced and cross sectional area is increased

3.A 3phase load is balanced, if all the 3 phases have the same :
(A)impedance
(B)Power factor
(C )impedance and power factor
(D)None of the above

4.Candela is the unit ....etc

[:=Read Full Message Here=:]

161/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.Which constituent in the earth gives plasticity to mould bricks?
(A)Lime
(B)Magnesia
(C ) Silica ’
(D) Alumina

2.The distance from the optical centre to the principle focus of a lens :
(A)Radius of curvature
(B)Focal length
(C )Focus
(D)None of these

3.The study of static electricity ;
(A)Electronics
(C )Electrostatic
(B)Electrostatic Field 
(D)Electron gravity

4.In optical systems, the lens of system of lenses closest to the observer� ....etc

[:=Read Full Message Here=:]

67/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.Conventional signs and symbols are in constant use on :
(A)Large ScaleDrawingTO
(B)Sketching
(C )Small ScaleDrawing
(D)Free-hand Drawing

2.Which of the following bricks are expected to have highest percentage of water absorption by
its dry weight?
(A) Common Building Bricks
(B) ‘Engineering Bricks
(C ) Heavy Duty Bricks
(D) Fire bricks

3.. The minimum crushing strength of a first class brick is :
(A)3 N/mm2
(B)5.5 N/mm2
(C )7 N/mm2
(D)10.5 ....etc

[:=Read Full Message Here=:]

1.Which of the following compass is used to draw very large circle?
(A) Large compass(B)Beam compass
(C ) Drop compass(D)Bow compass

2.The trimmed size of A3 drawing sheet is :
(A) 297 x 420 mm(B)210 x 297 mm
(C ) 148 x 210 mm(D)420×594mm 420 x 594 mm

3.An angle which is less than 90° is called :
(A) Obtuse angle(B)Acute angle
(C ) Reflex angle(D)Straight

4.A triangle has two of its sides equal:
(A) Scalene triangle(B)Equilateral triangle
(C ) Isosceles triangle(D)Right angled triangle

5.It an object l ....etc

[:=Read Full Message Here=:]