161/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.Which constituent in the earth gives plasticity to mould bricks?
(A)Lime
(B)Magnesia
(C ) Silica ’
(D) Alumina

2.The distance from the optical centre to the principle focus of a lens :
(A)Radius of curvature
(B)Focal length
(C )Focus
(D)None of these

3.The study of static electricity ;
(A)Electronics
(C )Electrostatic
(B)Electrostatic Field 
(D)Electron gravity

4.In optical systems, the lens of system of lenses closest to the observer� ....etc

[:=Read Full Message Here=:]

210/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1. The main reinforcement in a simply supported RCC member placed at:
(A) Top fibre
(B)Side fibre
(C ) Bottom fibre
(D)None of these

2.If the load at the free end cantilever beam is increased the failure will occur at
(A) Free end
(B)Centre
(C ) Support
(D)None of the above

3.Chemically, marble is known as :
(A) Siliceous rock
(B)Metamorphic rock
(C ) Argillaceous rock
(D)Calcareous rock

4.Brick lintels are used when the span is :
(A) Less ....etc

[:=Read Full Message Here=:]

67/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.Conventional signs and symbols are in constant use on :
(A)Large ScaleDrawingTO
(B)Sketching
(C )Small ScaleDrawing
(D)Free-hand Drawing

2.Which of the following bricks are expected to have highest percentage of water absorption by
its dry weight?
(A) Common Building Bricks
(B) ‘Engineering Bricks
(C ) Heavy Duty Bricks
(D) Fire bricks

3.. The minimum crushing strength of a first class brick is :
(A)3 N/mm2
(B)5.5 N/mm2
(C )7 N/mm2
(D)10.5 ....etc

[:=Read Full Message Here=:]

141/2016
Maximum: 100 marks
Time : 1 hour and 15 minutes

1. Box of prismatic compass is made of:
(A)copper(B)nickel
(C ) brass(D) none of these

2.The specific gravity of stone should not in any case less than :
(A)2.5 (B)2
(C )1.5 (D)1

3.The rocks which are deposited in layers and can be easily split 

along such layers is known as:
(A)aqueousrock
(B)sedimentary rock
(C )metamorphic rock
(D)basalt

4.The extend of land that gets irrigated from a water source is :
(A) duty '
(B) delta
(C )ayacut
( ....etc

[:=Read Full Message Here=:]

1. Which of the following is used in ceiling fan?
(A) Universal motor(B)Synchronous motorSynchronous motor
(C ) Series motor(D)Induction motorInduction motor

2.Active power in 3 phase circuit is :
(A) -»/3 VLILcosfφ (B)3 VLIL cosφ 3 VLIL cosφ 
(C ) V3 VrhIrhco8φ (D)•/a vh. V sinφ 

3.Unit of luminous intensity :
(A) Lumen(B)LuxLux
(C ) Lumen/m2(D)CandelaCandela

4.The power factor of pure resistive circuit is :
(A) Zero(B)LeadingLeading
(C ) Lagging(D)UnityUnity

5.Illumination of a surface is inv ....etc

[:=Read Full Message Here=:]

41/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.An under reinforced section is preferred than an over reinforced section because of:
(A)The steel reaches its maximum stress earlier
(B)Brittle property of concrete
(C )High strength of concrete 
(D) Cost of steel is high

2.When a slab is considered as two way slab, its long span to short .span ratio is :
(A)less than 2
(B) greater than 2
(C ) less than 1.5
(D) none of these

3.In the shape test of aggregates the particle whose least dimension is ....etc

[:=Read Full Message Here=:]

102/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1. The international nautical mile is same as :
(A)18.52 Km/hr
(B)1.609 Km/hr
(C ) 1.852 Km/hr
(D)16.09 Km/hr

2.The true weight of a granular material is its :
(A)Specific Gravity x Weight of Water
(C ) Density x Volume
(B) mxa
(D) Mass / volume

3.The Property of a solid to sustain shock load without permanent deformation 
(A)Tenacity
(B) Quenching
(C ) Milling
(D) Resilience

4.The pH value of strong caustic soda is about:
(A)7
(B) 13
(C ....etc

[:=Read Full Message Here=:]

1.The narrow strip of drawing board are joint together byjoints.
(A) Butt and lap joints(B)Lapped and splayed joints
(C ) Tongue and groove joint(D)Butt and dovetail jointsButt and dovetail joints

2.Which wood is used to made wooden T-Square? 
(A) Teak(B)Oak
(C ) Pine(D)Linoleum

3.The designation of standard recommended scalesof 1:10 and 1: 20 is :
(A) M2(B)M 4
(C ) M 5(D)M 3M3

4.The trimmed size of A2 drawing sheet in mm is :
(A) 297x 420(B)420x594
(C ) 594 x 841(D)-210 x 297 .

5.Which type of line is us ....etc

[:=Read Full Message Here=:]

1.Concurrent forces are those forces whose line of action?
(A)Meet at one point (B) Lie on the same line
(C ) Meet on the same plane (D) None of these

2.The angle between two forces when the resultant maximum and 

minimum respectively are?
((A)0° and 180c (B) 180° and 360°
(C ) 90° and 180° (D) 90° and 360°

3.When the spring of a watch is wound, it will posses
(A)Strain (B)Kinetic energy
(C ) Heat energy (D)Electrical energy

4.The moment of inertia of a rectangular section 3 cm wide and 4 

cm d ....etc

[:=Read Full Message Here=:]

1.1 volt is equal to :
(A)One coulomb per second
(B)One joule per coulomb
(C )One coulomb per joule
(D)Work done is transfering a charge of one coulomb

2.Theresistance of a conductor increases as its:
(A)Gross sectional area decreases
(B)Length decreases
(C )Resistivity decreases
(D)length is reduced and cross sectional area is increased

3.A 3phase load is balanced, if all the 3 phases have the same :
(A)impedance
(B)Power factor
(C )impedance and power factor
(D)None of the above

4.Candela is the unit ....etc

[:=Read Full Message Here=:]