1.The study which used to find a simpler, easier and better.way of performing a job is known as :
(A)Motion study
(B)Time study
(C )Time and motion study
(D)None of the above

2.The critical path in PERT is determined on the basis of:
(A)Maximum float of the each activity motion study
(B)Minimum float of each activity
(C )Slack of each event
(D)All of each above

3.The direct cost required to complete the activity in normal time duration is known as :
(A)Normal cost(B)Minimum cost
(C )Crash cost(D)None of the ab ....etc

[:=Read Full Message Here=:]

1.Which of the following compass is used to draw very large circle?
(A) Large compass(B)Beam compass
(C ) Drop compass(D)Bow compass

2.The trimmed size of A3 drawing sheet is :
(A) 297 x 420 mm(B)210 x 297 mm
(C ) 148 x 210 mm(D)420×594mm 420 x 594 mm

3.An angle which is less than 90° is called :
(A) Obtuse angle(B)Acute angle
(C ) Reflex angle(D)Straight

4.A triangle has two of its sides equal:
(A) Scalene triangle(B)Equilateral triangle
(C ) Isosceles triangle(D)Right angled triangle

5.It an object l ....etc

[:=Read Full Message Here=:]

1.A cycle consists of two isothermal and two isentropic processes is known as :
(A)Otto cycle(B) Joule cycle
(C )Stirling cycle(D)Carnotcycle

2.In an isometric projection the radius of a sphere it is equal to :
(A)0.82 R(B)R
(C )1.22 R(D)2 R

3.The function of steam nozzle is to convert:
(A)heat energy steam into kinetic energy
(B)heat energy steam into rotational energy
(C )kinetic energy into heat energy of steam
(D)heat energy steam into pressure energy

4.Dryness fraction is the ratio of:
(A)mass of dry st ....etc

[:=Read Full Message Here=:]

1.A fan may be considered as a pump, because it:
(A)looks like most other kind of pumps(B)circulate fluids, like other pumps
(C )rotates(D)all of these

2.If N is the fan speed, then power of a fan is directly proportional to:
(A)N(B)N2
(C )N3(D)N4

3.For rectangular ducts, the aspect ratio is equal to :
(A)sum of longer and shorter sides(B)difference of longer and shorter sides
(C )product of longer and shorter sides(D)ratio of longer and shorter sides

4.Thealignment circle is marked on thepsychrometric chart ....etc

[:=Read Full Message Here=:]

88/2014
Mnximum: 100 marks
Time : 1 hour and 15 minutes

1.LED is made of:
(A) Silicon
(B)Germanium
(C ) Gallium Arsenide .
(D)Selenium

2.The resonant frequency of a parallel tuned circuit is :
(A)f1 1/2 RC
(B)'' 2 fC
(C )f1 2 /R
(D)-2√LC

3.In an ideal Op-amp, Output impedance (ZOut) will be:
(A) co
(B)on
(C ) 10sΩ
(D)None of the above

4.The Collector-base junction of a transistor is always :
(A) Forward biased
(B)Reverse biased
(C ) Unbiased
(D)None of the above

5.Colour coding of ....etc

[:=Read Full Message Here=:]

Maximum : 100 marks
Time : 2 hours and 30 minutes Answer ALL questions in ENGLISH.
From the details given below write up the cash book of Shri R. Executive Engineer, for the month of November 2015 indicating the classification and close it giving an analysis of the
closing balances.

1.11.15Contents of the cash cheat
(a)Notes100
(b)Service Postage Stamps20
(c )Revenue Stamps5
(d)Cheque dated 31.10.2015 on account of Rent from Mr. X145
(e)Undisbursed amount of TA advance of a clerk belonging
to the EE’s establis ....etc

[:=Read Full Message Here=:]

1.A cycle consists of two isothermal and two isentropic processes is known as :
(A)Otto cycle(B) Joule cycle
(C )Stirling cycle(D)Carnotcycle

2.In an isometric projection the radius of a sphere it is equal to :
(A)0.82 R(B)R
(C )1.22 R(D)2 R

3.The function of steam nozzle is to convert:
(A)heat energy steam into kinetic energy
(B)heat energy steam into rotational energy
(C )kinetic energy into heat energy of steam
(D)heat energy steam into pressure energy

4.Dryness fraction is the ratio of:
(A)mass of dry st ....etc

[:=Read Full Message Here=:]

PART I
Answer ALL questions. Answer in one word or a sentence. Questions 1 to 30 carry 4 marks each.
1.Which one of the following cast irons consists of carbon in rosette form?
(a)White cast iron(b) Gray cast iron
(c )Malleable cast iron(d) Nodular cast iron

2.The specific speed of a centrifugal pump depends on the
(a) Speed and discharge(b)Discharge and power developed
(c ) Speed and head of water(d)Speed, discharge and head of water

3.The annual load factor and the capacity factor in a power plant is 0.6 and 0.5 ....etc

[:=Read Full Message Here=:]

Maximum : 100 marks
Time : 2 hours
Answer ALL questions in ENGLISH.

I.(a) Define the term Open access.(a)Define the term Open access.(2)
(b)What is the procedure to grant licensee to a distribution utility?(8)

II.Explain the constitution and duties of the Authority.(20)

III.(a)What are the responsibilities of Regional Load Dispatch Centre?(5)
(b)What are the powers of Regulatory Commissions?(10)

IV.(a)Which are the components of tariff for supply of electricity froma thermal generating 1 station?(10)
(b)Whi ....etc

[:=Read Full Message Here=:]

104/2014
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.The Poisson’s ratio of a material is 0.4. If a force is applied to this material, there is a decrease in cross sectional area by 2%. The percentage increase in its length is :
(A) 0.25%
(B)0.5%
(C ) 2.5%
(D)3%

2.The difference between LST and EST is called :•
(A) Activity
(B)Event
(C ) Float
(D)Critical path

3.Identify the method which is not a LPP technique :•
(A) Graphical method
(B)Transportation problem
(C ) Simplex method
(D)ABC an ....etc

[:=Read Full Message Here=:]