HIGH SPEED MACHINING
ABSTRACT
Over the past 60 years, high speed machining (HSM) has been applied to a wide range of metallic and non-metallic work piece materials including the production of components with specific topography requirements and machining of materials with hardness of 50 HRC and above.
With most steel components hardened to approximately 32-42 HRC, machining operations currently include:
Rough machining and semi-finishing of the material
Heat treatment to ach ....etc

[:=Read Full Message Here=:]

The unconventional method of several specific advantages over conventional methods of machining and these promise formidable tasks to be undertaken and set a new recording in the manufacturing technology. EDM is one such machining process, which has been immense help to the manufacturing process engineers to produce intricate shapes on any conducting metal and alloy irrespective of its hardness and toughness.


CLASSIFICATION

1. Contact initiated discharge
2. Spark initiated discharge
3. Electrolytic discharge

ADVANTAGES

1. The pr ....etc

[:=Read Full Message Here=:]

Manufacturing of the intricate machines has taken a new dimension with the introduction of the innovative process of chemical, electrical and mechanical methods. Electrochemical machining (ECM) is a groundbreaking technology, for the development of complicated machines. ....etc

[:=Read Full Message Here=:]

The recent increase in the use of hard, high strength and temperature resistant materials in engineering necessitated the development of newer machining techniques. Conventional machining or finishing methods are not readily applicable to the new materials like hastalloy, nitralloy, waspalloy, nimonics, carbides, ceramics etc.


Conventional machining processes when applied to these newer materials:
1. Are uneconomical,
2. Produce poor degree of surface finish and accuracy,
3. Produce some stress,
4. Highly insufficient.

Newer machin ....etc

[:=Read Full Message Here=:]

In electron-beam machining (EBM), electrons are accelerated ..
In electron-beam machining (EBM), electrons are accelerated to a velocity nearly three-fourths that of light.

The process is performed in a vacuum chamber to reduce the scattering of electrons by gas molecules in the atmosphere.

The stream of electrons is directed against a precisely limited area of the workpiece;

on impact, the kinetic energy of the electrons is converted into thermal energy that melts and vaporizes the material to be removed, forming holes or cuts.
....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

hi friend
i am new this site
can you help me for my seminar

i have selected the tpopicLASER BEAM MECHINING.

if it possible post me both seminar and ppt ok

plzzzz ....etc

[:=Read Full Message Here=:]

electonic discharge machining with full ppt and report... ....etc

[:=Read Full Message Here=:]

Electro Discharge Machining


The unconventional method of several specific advantages over conventional methods of machining and these promise formidable tasks to be undertaken and set a new recording in the manufacturing technology. EDM is one such machining process, which has been immense help to the manufacturing process engineers to produce intricate shapes on any conducting metal and alloy irrespective of its hardness and toughness.


CLASSIFICATION

1. Contact initiated discharge
2. Spark initiated discharge
3. Electrolytic dis ....etc

[:=Read Full Message Here=:]

A SEMINAR ON
ADAPTIVE CONTROL MACHINING
ABSTRACT

Adaptive control system is a logical extension of the CNC-mechanism. In CNC mechanism the cutting speed and feed rates are prescribed by the part programmer. The determination of these operating parameters depends on the Knowledge and experience regarding the work piece, tool materials, coolant conditions and other factors.
By contrast in adaptive control machining, there is improvement in the production rate and reduction in t ....etc

[:=Read Full Message Here=:]