Abstract
Most device drivers have one ulterior motive and one target to achieve - deliver the maximum using the minimum. No matter how stable or feature rich a device driver might be, if it cannot perform in terms of high throughput and low CPU utilization, it is as good as any other run of the mill driver.The objective of this topic is to use the thinking out of the box concept and expose techniques, which go beyond just good programming principles to get that extra edge which can put your next driver into the elite group of high perform ....etc

[:=Read Full Message Here=:]

i want a seminae report on gyroscopic propulsion.... ....etc

[:=Read Full Message Here=:]

looking to attend a seminar on fiber optics gyroscopes physics and applications. can be a separate seminar or a topic of a larger seminar. ....etc

[:=Read Full Message Here=:]

I begin to use the comsol bofore two days, and I need some help for using comsol to simulate the solar cell,such as how to set the model of solar cell ,and so on ....etc

[:=Read Full Message Here=:]

DEPARTMENT OF ELECTRONICS & COMMUNICATION ENGG.

KURUKSHETRA INSTITUTE OF TECHNOLOGY & MANAGEMENT
KURUKSHETRA- 136119



Microelectromechanical systems
Microelectromechanical systems (MEMS) (also written as micro-electro-mechanical, MicroElectroMechanical or microelectronic and microelectromechanical systems) is the technology of very small mechanical devices driven by electricity; it merges at the nano-scale into nanoelectromechanical systems (NEMS) and nanote ....etc

[:=Read Full Message Here=:]

Under the Guidance of Dr. Patil Basavaraj VDept of IP & E
Submitted By Deepak Kothari

Introduction to CWR

The CWR is a rotary forming process, consists
of the forming of forging by means of wedge-shaped tools that are fixed on the mill rolls with the same rotary direction.
In CWR process, there are five stages in the work piece deformation process corresponding to five zones of the wedged tool geometry, i.e., knifing, guiding, stretching, shaping, and siz ....etc

[:=Read Full Message Here=:]

http://freespaceopticsfreespaceoptics/images/flightstrata_photo.jpg
Free space optical communications is a line-of-sight (LOS) technology that transmits a modulated beam of visible or infrared light through the atmosphere for broadband communications. In a manner similar to fiber optical communications, free space optics uses a light emitting diode (LED) or laser (light amplification by stimulated emission of radiation) point source for data transmission. However, in free space optics, an energy beam is collimated and transmitted t ....etc

[:=Read Full Message Here=:]

Kindly guide me for preparing project in
OPTICAL NETWORK /OPTICAL SWITCHING IN TELECOM NETWORK

Regards

Niranjan ....etc

[:=Read Full Message Here=:]

OPTICAL devices

INTRODUCTION
Explosive information demand in the internet world is creating enormous needs for capacity expansion in next generation telecommunication networks. It is expected that the data- oriented network traffic will double every year. Optical networks are widely regarded as the ultimate solution to the bandwidth needs of future communication systems. Optical fiber links deployed between nodes are capable to carry terabits of information but the electronic switching at the nodes limit th ....etc

[:=Read Full Message Here=:]

Abstract:

In this paper, analysis of CDMA network with Optical Amplifiers has been done. As the optical amplifier provides gain as well as has nonlinear characterstics, gain is expected due to signal amplification as well as operation of SOAs as limiter due to gain saturation. In this paper results have been computed for with different SOA placements in a typical star topology employing CDMA. The results show that in a star topology network employing CDMA, placement of SOAs before CDMA decoder does provide benefit due to g ....etc

[:=Read Full Message Here=:]