I am doing my M.tech in power electronics division.This is karthik....
I want designing aspects of buck boost matrix converter.Currently I am simulating the circuit.hardware design calculations of buck boost matrix converter is required.
Designing aspects means calculation of component values.... ....etc

[:=Read Full Message Here=:]

hii, i want more information about the Optimal Intelligent Controller for Matrix Converter Induction Motor Drive System
thank you ....etc

[:=Read Full Message Here=:]

submitted by :
Ashish Sharma
Ashok Kr. Kumawat
Balraj Sharma
Satyanarayan Agarwal
Tarun Mandawat


WHAT IS DTC ?
 Direct torque control is known to produce quick and robust response in AC drive system.
 Direct Torque Control describes the way in which the control of torque and speed are directly based on the electromagnetic state of the motor.
 Direct Torque Control is a direct ....etc

[:=Read Full Message Here=:]

DTC Level SCADA
In DTC level we want connect all Distribution Transformer to the Sub-station SCADA via
RTU or PLC
In this SCADA system we want monitor and control the Distribution Transformer through SCADA System
Here we want to measure all parameters of Distribution Transformer and there status with the help of MSEB meters or other Multifuction Meters with wireless Communication
In this communication we can use GSM/CDMA system. The meters are send data to sub-station RTU through GSM network
....etc

[:=Read Full Message Here=:]

please i need a simulink file for direct torque control for PMSM
thankyou ....etc

[:=Read Full Message Here=:]

Abstract –
The matrix converter is superior to the P W inverter drives because of its regeneration ability and sinusoidal input current. Therefore, it meets the stringent energy-efficiency and power quality requirements of the new century. This paper describes the basic operating principles and control method of the matrix converted; and reports the detailed experimental operating characteristics of an I1 kVA matrix converter drive over its full operating range. Through the experimental operating characteristics ....etc

[:=Read Full Message Here=:]

1. Analysis of Different Schemes of Matrix Converter with Maximum Voltage Conversion Ratio
2. Single-Phase Z-Source Buck-Boost Matrix Converter
3. Single-Phase Matrix Converter Operating as Buck and Boost Rectifier
4. Analysis and implementation of Matrix Converter
....etc

[:=Read Full Message Here=:]

ABSTRACT

The rectifier and inverter are used in vector control of induction motor. The most shortcomings are that exist a big capacitor and energy pass only from power sources to load. This paper details a novel matrix converter-indirect matrix converter. It is used in vector controlling research of induction motor and displaced for conventional inverter to supply power for induction motor. Because switches are bidirectional in the rectifier, it can realize bidirectional pass of the energy and decrease pollution of harmonic wave. Meanwhile ....etc

[:=Read Full Message Here=:]

Abstruct-
Analysis, design, and implementation of the space vector modulated three-phase to three-phase matrix converter with input power factor correction are presented. The majority of published research results on the matrix converter control is given an overview, and the one, which employs sheous output-voltage and input-current space vector modulation, is systematically reviewed. The modulation algorithm is theoretically derived from the desired average transfer functions, using the indirect transfer function approach. ....etc

[:=Read Full Message Here=:]

i have a problem in simulation of DTC-SVM
 five phases induction motor ..... i have the simulation on the three
phases  but whene
i changed it into five phases  i got a false results  and i didn't
find the problem please can anyone help me please ....etc

[:=Read Full Message Here=:]