Estun servo system’ application in CNC system



Servo system is a kind of electrical transmission system for the mechanical
movement. Its control objective is servo motor, and the core unit, servo drive. Servo
system’ functions are instructed with the automatic control theory and its mechanical
execution is through power transformation module of electric power and electronics
system. For the whole CNC system, servo system receives instructions of moving
distances and speeds sent by CNC. And then when these in ....etc

[:=Read Full Message Here=:]

Low voltage differential signaling, or LVDS, is an electrical signaling system that can run at very high speeds over cheap, twisted-pair copper cables. It was introduced in 1994, and has since become very popular in computers, where it forms part of very high-speed networks and computer buses.
LVDS uses the difference in voltage between two wires to signal information. The transmitter injects a small current, nominally 3.5 milliamperes, into one wire or the other, depending on the logic level to be sent. The current passes through a resistor o ....etc

[:=Read Full Message Here=:]

CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS
INTRODUCTION TO DRIVES

Mechanical components used for power transmission.It may be belt, chain or gear depending on engine design parameters like - Distance between crankshaft and camshaft, engine maximum speed, engine-torque and engine construction cost.- Power transmission is done from one shaft to another shaft which may or may not rotate at same spe ....etc

[:=Read Full Message Here=:]

How it works ...



The Piezoelectric effect in piezoceramics converts electrical field to mechanical strain. Under special electrical excitation drive and ceramic geometry of Nanomotion motors, longitudinal extension and transverse bending oscillation modes are excited at close frequency proximity. The simultaneous excitation of the longitudinal extension mode and the transverse bending mode creates a small elliptical trajectory of the ceramic edge, thus achieving the dual mode standing w ....etc

[:=Read Full Message Here=:]

How can i use pic micro controller chip for controlling Servo motor ,can any one provide me with a code to burn? ....etc

[:=Read Full Message Here=:]

PRESENTED BY:
P. BHAVYA GEETHIKA


Position Control of Manipulator using PMAC with DC Servo Motors
ORGANIZATION PROFILE
The “Defence Research and Development Laboratory” (DRDL) in Hyderabad, formerly directed by A.P.J. Abdul Kalam, is the main research center for the Integrated Missile Development Program. It is located in the Defence Research Complex at Kanchanbagh, on the periphery of Hyderabad Old City.
“Defence Research & Development Laboratory” (D.R.D.L) is one of the laboratories of DRDO, w ....etc

[:=Read Full Message Here=:]

difference between chopper fed drives and converter fed drives pdf ....etc

[:=Read Full Message Here=:]

Low-Voltage Differential Signaling (LVDS) is a new technology addressing the needs of today's high performance data transmission applications. The LVDS standard is becoming the most popular differential data transmission standard in the industry. This is driven by two simple features: Gigabits @ milliwatts! LVDS delivers high data rates while consuming significantly less power than competing technologies. In addition, it brings many other benefits, which include:

a)Low-voltage power supply compatibility
b)Low noise generation
c)High no ....etc

[:=Read Full Message Here=:]

Abstract—This paper is to design a controller for servo motor in discrete-time systems. The experimental is used to obtain the transfer function to design the PID controller. The effectiveness of the design is validated using MATLAB/Simulink.This new design method gives us a simple and powerful way to design a speed controller for a servo – motor. In this study DC servo motor’s mathematical model and equation were extracted and there were three different motion controller designed for control the velocity It wa ....etc

[:=Read Full Message Here=:]

dear sir/madam..
i'm prabhu... i want to know how to interface servo motor with 8085 microprocessor...? ....etc

[:=Read Full Message Here=:]