Pls send me a project report on Fire and Safety Engineering. ....etc

[:=Read Full Message Here=:]

1.Consumption of raw soybeans can be harmful to health because of the presence of following anti-nutritional factor:
(A)Phytic acid(B)Tannins
(C )Oxalates(D)Trypsin inhibitor

2.In a standard fruit jam preparation the content of total soluble solids should not be less than :
(A)68% W/W(B)45% WAV
(C )65% W/W(D)70% W/W

3.The safe level of irradiation for foods, which presents no toxicological hazard is :
(A)5.0 kGy(B)10.0 kGv
(C )7.0 kGy(D)25.0 kGy

4.Subjecting rice to higher degree of polishing is associated with ....etc

[:=Read Full Message Here=:]

The low or high resistivity soil layer formed in raining or freezing season affects the safety of grounding system, and leads the changes of grounding resistance of the grounding system, step and touch voltages on the ground surface.

This paper systematically discusses the seasonal influence on the safety of grounding system and the different methods to be adopted inorder to nullify the effect of seasonal changes.
Inorder to nullify the effect of the seasonal changes we can use long vertical grounding electrodes or by using chemically cha ....etc

[:=Read Full Message Here=:]

Managing construction sites are difficult due to temporary work nature, changing work area, untrained workers, over time works etc., Most of the accidents occurred in construction activities like building structures, demolition, excavation, roof work, alteration, scaffolding, painting etc,. In typical construction works about 1500 people are killed in Britain and 25,000-30,000 more are seriously injured. The accident statistics represent not only serious human tragedies but also substantial economical losses due to accidents which cause damage ....etc

[:=Read Full Message Here=:]

Need details about identification of safety requirements in software engineering ....etc

[:=Read Full Message Here=:]

Introduction

With the development of modern power system to the direction of extra-high voltage, large capacity, far distance transmission and application of advanced technologies the demand on the safety, stability and economic operation of power system became higher. A good grounding system is the fundamental insurance to keep the safe operation of the power system. The good grounding system should ensure the following:

To provide safety to personnel during normal and fault conditions by limiting step and touch potential.
To assur ....etc

[:=Read Full Message Here=:]

Definition

An automotive controller that complements the driving experience must work to avoid collisions, enforce a smooth trajectory, and deliver the vehicle to the intended destination as quickly as possible. Unfortunately, satisfying
these requirements with traditional methods proves intractable at best and forces us to consider biologically -inspired techniques like Swarm Intelligence.

A controller is currently being designed in a robot simulation program with the goal of implementing the system in real hardware to investigate these ....etc

[:=Read Full Message Here=:]

Definition

Success is all about being in the right place at the right time ?.. and the axiom is a guiding principle for designers of motorsport circuits. To avoid problems you need know where and when things are likely to go wrong before cars turn a wheel -and anticipating accidents is a science.

Take barriers, for example .there is little point erecting them in the wrong place -but predicting the right place is a black art. The FIA has developed bespoke software, the Circuit and Safety Analysis System (CSAS), to predict problemareas on F ....etc

[:=Read Full Message Here=:]

SAFETY CRITICAL ELEMENT IDENTIFICATION
PERFORMANCE STANDARD AND ENGINEERING
VERIFICATION FOR OIL AND GAS INSTALLATION
FESTIN TOMY
ENGINEER - SAFETY DESIGN
PETROFAC INTERNATIONAL LTD.
SHARJAH, UAE
[email protected]
Introduction
The overall objective of the Engineering
Verification for oil and gas installations is to
ensure independent and competent scrutiny of
those parts of the installation that is critical to
safety, and to obtain assurance of the
satisfactory condition of such items.
Identification of the Safety Criti ....etc

[:=Read Full Message Here=:]

hi am Sujay, student of final year engineering in Industrial Engineering And Management course. Am looking for a technical seminar report on Virtual Reality Modelling Of Occupational Safety Engineering. Kindly help me out with it . ....etc

[:=Read Full Message Here=:]