ENHANCEMENT OF VEHICLE STABILITY BY ACTIVE GEOMETRY
CONTROL SUSPENSION SYSTEM
1. INTRODUCTION
In recent years, there has been increased need to develop high-performance suspension for high-power engines ,especially active chassis control systems have been developed and mass-produced in the market to compromise vehicle ride and handling performance simultaneously,
The conventional active chassis control systems control the vehicle phenomenon such as body roll, yaw, and pitch using hydraulic actuators w ....etc

[:=Read Full Message Here=:]

Good evening,
I have an image of a hand with only contour, and i need to recognize the characteristic points (tip points and valley points of the hand)
I need a code matlab for hand geometry recognition, which can extract the main features on the hand, I need a code that can find those features, the finger tips mainly, the length et the width of the fingers as well.
thank you for your help. ....etc

[:=Read Full Message Here=:]

Preprocessing code for hand geometry using matlab ....etc

[:=Read Full Message Here=:]

Coordinate Geometry Questions
Distance Formula: d = (x2 - x1)2 + (y2 - y1)2

1. Find the distance between the points
(a) (0, 2) and (3, 6) (b) (-2, 3) and (4, -5) (c) (2, -5) and (-3, 7)
2. Find the exact length of the interval between points
(a) (2, 3) and (-1, 1) (b) (-1, 3) and (-7, 7)
3. Prove that the triangle with vertices (3, 4), (-2, 7) and (6, -1) is isosceles.
4. Show that the points (3, -4) and (8, 1) are equidistant from the point (7, -3).
5. Prove ....etc

[:=Read Full Message Here=:]

Abstract—This paper presents positioning algorithms for cellular network-based vehicle tracking in severe non-line-of-sight (NLOS) propagation scenarios. The aim of the algorithms is to enhance positional accuracy of network-based positioning systems when the GPS receiver does not perform well due to the complex propagation environment. A one-step position estimation method and another two-step method are proposed and developed. Constrained optimization is utilized to minimize the cost function which takes account of the NLOS error so that th ....etc

[:=Read Full Message Here=:]

i need complete information abt Personal Authentication Using 3-D Finger Geometry. please help me by mailing the details of the project on [email protected]. thank you. ....etc

[:=Read Full Message Here=:]

sir/madam,

please give me matlab code for hand geometry and material

RESPECTED SIR/MADAM,
PLEASE GIVE MATLAB CODE FOR HAND GEOMETRYAND MATERIAL
....etc

[:=Read Full Message Here=:]

Presented By:
R.J. Stafford, J.M. Mulloy, T.M. Yonushonis, H.G. Weber, and M.J. Patel
Cummins Engine Company

INTRODUCTION

Turbocharging of diesel engines has enhanced fuel economy and reduced diesel engine emissions. The initial applications of turbochargers to heavy duty diesel engines during the early 1970's reduced Bosch smoke (a measure of particulate matter used at the time) from 2.4 to 0.6 units. At the same time, engine specific fuel consumption was reduced from 0.36 Ib./bhp-hr to 0.35 ib./bhp-hr. Since that time, a vari ....etc

[:=Read Full Message Here=:]

ENHANCEMENT OF VEHICLE STABILITY BY ACTIVE GEOMETRY
CONTROL SUSPENSION SYSTEM


1. INTRODUCTION

In recent years, there has been increased need to develop high-performance suspension for high-power engines ,especially active chassis control systems have been developed and mass-produced in the market to compromise vehicle ride and handling performance simultaneously,
The conventional active chassis control systems control the vehicle phenomenon such as body roll, yaw, and pitch using hydraulic actuators with the same directi ....etc

[:=Read Full Message Here=:]

TURBO CHARGING BY VARIABLE VANE GEOMETRY



INTRODUCTION TO TURBOCHARGING


A turbocharger, or turbo, is a centrifugal compressor powered by a turbine which is driven by an engine's exhaust gases. Its benefit lies with the compressor increasing the pressure of air entering the engine thus resulting in greater performance (for either, or both, power & efficiency). They are popularly used with internal combustion engines (e.g. four-stroke engines like Otto cyc ....etc

[:=Read Full Message Here=:]