Abstract—
We consider an end-to-end approach of inferring probabilistic data-forwarding failures in an externally managed overlay
network, where overlay nodes are independently operated by various administrative domains. Our optimization goal is to minimize the
expected cost of correcting (i.e., diagnosing and repairing) all faulty overlay nodes that cannot properly deliver data. Instead of first
checking the most likely faulty nodes as in conventional fault localization problems, we prove that an optimal strategy should start wit ....etc

[:=Read Full Message Here=:]

1. INTRODUCTION
FUTURE optical networks will extend wavelength division multiplexing (WDM) technology to take full advantage of the wide bandwidth of the fiber to meet with the rapidly increasing demand for communication capacity. Large WDM networks will require wavelength converters for signal path routing, and this will enable us to use wavelength resources efficiently and realize flexible network construction.
Several wavelength-conversion methods have already been proposed , including cross-gain or cross-phas ....etc

[:=Read Full Message Here=:]

Presented by:
S.KAVITHA


Strengthening Of CorrosionInflicted RC Beams Using FRP Wrap
Objective
The loss of stiffness caused by corrosion regained by FRP application
Confine concrete and improve the compressive strength
Decreased corrosion rates due to FRP application
Substantial increase in the ultimate strength
Stress-strain curves for FRP products
Properties of FRP composites
Corrosion damage of a concrete beam
Methodology
Experimental programme
Corrosion infliction
Process of inducing c ....etc

[:=Read Full Message Here=:]

Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

Deflection of beams
Abstract
The basic aspects of Probe Beam Deflection techniques, used to detectconcentration gradients in electrochemical systems, are described.
The different techniques is first discussed. Then, a critical review of published applications of the techniques to various electrochemical systems is performed. Among the systems whom these techniques has been applied are: electrochromic oxides, conducting polymers, redox polymers, underpotential deposition, surface electrochemical reaction on solid ele ....etc

[:=Read Full Message Here=:]

Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

ABSTRACT
This paper presents the results of experimental studies concerning the flexural strengthening of RC beams using externally bonded Slurry Infiltrated Mat CONcrete (SIMCON) laminates. A total of four reinforced concrete beams were cast and tested in the laboratory over an effective span of 3000 mm. Three beams were strengthened with bonded SIMCON laminate at the bottom under virgin condition and tested until failure; the remaining one beam was used as control specimen. Static responses of all the beams w ....etc

[:=Read Full Message Here=:]

retrofitting of rc beams with externally bonded simcon laminates ....etc

[:=Read Full Message Here=:]

Fatigue Behavior of Reinforced Concrete Beams Strengthened with Different FRP Laminate Configurations
Synopsis: This paper presents testing results of thirteen small-scale beams
strengthened using carbon fiber-reinforced polymer composites tested under repeated
loads to investigate their fatigue behavior. The beams were strengthened using
different thicknesses and widths of composite laminates to identify parameters that
would generate different failure modes. Two predominant fatigue failure modes were
identified through these tes ....etc

[:=Read Full Message Here=:]

Presented by:
M. Sekar, L.M.Poornima


The high cost of conventional building materials is a major factor affecting housing delivery in world. This has necessitated research into alternative materials of construction. The project paper aims at analyzing flexural and compressive strength characteristics of concrete produced using crushed, granular coconut as substitutes for conventional coarse aggregate with partial replacement using M30 grade concrete. Beams are casted, tested and their physical an ....etc

[:=Read Full Message Here=:]