CMOS Integrated DTMF Receiver

Features
• Full DTMF receiver
• Less than 35mW power consumption
• Industrial temperature range
• Uses quartz crystal or ceramic resonators
• Adjustable acquisition and release times
• 18-pin DIP, 18-pin DIP EIAJ, 18-pin SOIC, 20-pin
PLCC
• CM8870C
— Power down mode
— Inhibit mode
— Buffered OSC3 output (PLCC package only)
• CM8870C is fully compatible with CM8870 for 18-pin
dev..............etc

[:=Read Full Message Here=:]

Common mode rejection ratio (CMRR) is important performance parameter of any difference amplifier. It is the ratio of the differential gain to the common-mode gain, generally expressed in dB. It signifies the ability of an opamp to reject common mode signal, the signal which appears simultaneously at both its input terminals. The CMRR is of great importance when it comes to noise rejection. For applications involving high CMRR, instrumentation amplifiers consisting of three opamps are generally used. It has a major disadvantage that the value o..............etc

[:=Read Full Message Here=:]

my respected coordinators,my name is amit navneet swain, i am from bhubaneswar,orissa and i am doing btech in GITA,bbsr. i want to know that why this class d amplifier is introduced to electronics?i mean what were the difficulties with the class ab amplifier?kindly explain me the reason........i expect i would get the best response from u......................etc

[:=Read Full Message Here=:]

Class-D Amplifiers

Class D amplifiers present us with a revolutionary solution, which would help us eliminate loss and distortions caused due to conversion of digital signals to analog while amplifying signals before transmitting it to speakers. This inchoate piece of knowledge could prove to detrimental in improving and redefining essence of sound and take it to a different realm.

This type of amplifiers do not require the use of D-A conversion and hence reduce the costs incurred for developin..............etc

[:=Read Full Message Here=:]

ABSTRACT
A single-chip CMOS Global Positioning System (GPS) radio has been integrated using only a couple of external passive components for the input matching network and one external reference for the synthesizer. The receiver downconverts the GPS L1 signal at 1575.42 MHz to an IF of 9.45 MHz. The complete front-end and frequency synthesizer section have been integrated: low noise amplifier, image rejection mixer, IF active filter, and the full phase-locked loop synthesizer, including voltage-controlled osci..............etc

[:=Read Full Message Here=:]

Class D amplifiers present us with a revolutionary solution, which would help us eliminate loss and distortions caused due to conversion of digital signals to analog while amplifying signals before transmitting it to speakers. This inchoate piece of knowledge could prove to detrimental in improving and redefining essence of sound and take it to a different realm.

This type of amplifiers do not require the use of D-A conversion and hence reduce the costs incurred for developing state of art output technology. The digital output from sources s..............etc

[:=Read Full Message Here=:]

1. INTRODUCTION

GLOBAL Positioning System (GPS) receivers for the consumer market require solutions that are compact, cheap, and low power. Manufacturers of cellular telephones, portable computers, watches, and other mobile devices are looking for ways to embed GPS into their products. Thus, there is a strong motivation to provide highly integrated solutions at the lowest possible power consumption. GPS radios consist of a front-end and a digital baseband section incorporating a digital processor. While for the baseband processor, cost-reduc..............etc

[:=Read Full Message Here=:]

Class D amplifiers present us with a revolutionary solution, which would help us eliminate loss and distortions caused due to conversion of digital signals to analog while amplifying signals before transmitting it to speakers. This inchoate piece of knowledge could prove to detrimental in improving and redefining essence of sound and take it to a different realm.

This type of amplifiers do not require the use of D-A conversion and hence reduce the costs incurred for developing state of art output technology. The digital output from sources s..............etc

[:=Read Full Message Here=:]

INTRODUCTION:
AMPLIFIER:
A circuit that increases the amplitude of a given input signal is called an amplifier. A small a.c. signal fed to the amplifier is obtained as a larger a.c. signal of the same frequency at the output.Amplifiers constitute an essential part of radio, television and other communication circuits. Bipolar junction transistors and Field effect transistors are commonly used as amplifying elements.
Amplifiers can be classified as follows:
1. Based on transistor conf..............etc

[:=Read Full Message Here=:]

I need to give a seminars, so i have chosen Fully Integrated CMOS GPS Radio because of less time i could not gather more information on my interested topic so i am in a need to get the hard and soft copy of the above topic.
i will be gracefull if you give me the clear cut details and report of Fully Integrated CMOS GPS Radio..............etc

[:=Read Full Message Here=:]