PRESENTED BY :
B.SRINIVASA RAO




INTRODUCTION

Two Data Communications (Parallel & Serial Data
Communications) Are Used in all Computers for
Data Transmission & Reception b/n host and
Serial Devices

SERIAL COMMUNICATION STANDARDS

Serial Communication means Data can be Transmitted One bit at a time in series, is called serial Data Communication.

In Generally Serial Communication Standard buses are 3 types.
There are :
1.) USB (Universal Serial Bus)
....etc

[:=Read Full Message Here=:]

A Linux Device Driver for USB to USB Direct Link Device

The first version of the Universal Serial Bus (USB) specification was released in January 1996. In April 2000, version 2.0 of the USB specification, which supports transfer rates up to 480 Mbps, was released. Because of its low cost, high data-transfer rate, ease of use, and flexibility, USB has gained wide acceptance in the computer industry. Today, many peripherals and devices connect to computers through USB interfaces. Currently, most general-purpose operating systems pro ....etc

[:=Read Full Message Here=:]

In third generation WCDMA systems, shared channels allow many users to jointly utilize a single Orthogonal Variable Spreading Factor (OVSF) code. In this paper, we propose a Scheduling Algorithm with Dynamic Priority Assignment (DPA) which is designed for the Downlink-Shared channel (DSCH) of 3G WCDMA systems and operates within a cross layer framework. The DPA scheduler has low computational complexity and is able to provide QoS differentiation among traffic flows based on their delay sensitivity. Through the cross layer framework, DPA takes i ....etc

[:=Read Full Message Here=:]

Efficiency Improvement of WCDMA Base Station Transmitters using Class-F power amplifiers


Muthuswamy Venkataramani



(ABSTRACT)
Universal Mobile Telecommunications Systems (UMTS) is the preferred third generation (3G) communication standard for mobile communications and will provide worldwide coverage, a convenient software technology and very high data rate. The high data rate, especially, requires the use of bandwidth-efficient modulation schemes such as Quadrature Phase Shift Keying (QPSK). But ....etc

[:=Read Full Message Here=:]

usb to usb data teansfer without using pc ....etc

[:=Read Full Message Here=:]

USB EXPLAINED: AN INTRODUCTION TO USB AND ITS FUTURE


USB HISTORY
The Universal Serial Bus (USB) was introduced to the world of PC computing to solve the growing problem of how
to connect peripherals to a PC. The world of desktop computers needed a way, not only to physically connect
devices, but also allow them to be identified and categorized to enable a simple ease of use and method of discovery.
Prior to USB, many people overloaded the use of their serial and ....etc

[:=Read Full Message Here=:]

sir, pls do provide me with the pdf for USB TO USB DATA TRANSFER WITHOUT PC USING MICROCONTROLLER.
kindly provide me the same.
thanking you,
your's faithfully
mithun krishnan k v ....etc

[:=Read Full Message Here=:]

my BSNL EVDO Prithvi data card is not work in my window 8 any body can tell me what i do.....that it runs on window 8 ....etc

[:=Read Full Message Here=:]

Presented by:
Rodger E. Ziemer


3G CDMA - WCDMA and cdma2000
Rules for Efficient Multiple Access
Three laws
 Know the channel
 Minimize interference to others
 Mitigate interference received from others
 Requirements of wireless multiple access
 Channel measurement
 Channel control and modification
 Multiple user channel isolation
Why CDMA?
 Higher capacity
 Improved performance in multipath by diversity
 Lower mobile transmit power = longer battery life
 ....etc

[:=Read Full Message Here=:]

Power control is one of the technologies used to utilize the radio resources as efficient as possible in WCDMA. The transmission power is adjusted to transmit with the lowest power level possible while the required received signal quality is maintained. Since there are large variation in channel quality over time, the power has to be adjusted to compensate for these variations. During moments of bad channel conditions a high transmission power has to be used which will to a greater extent interfere with other users in the system.To solve this ....etc

[:=Read Full Message Here=:]