Sir/Madam
Can i get the information regarding the above mentioned project topic. ....etc

[:=Read Full Message Here=:]

Introduction to Pulse Width Modulation (PWM)
In this technique several pulses are produced in each half – cycle but the width of the pulses
is not the same as in case of multiple – pulse width modulation, however the width of each pulse is
varied in accordance with the amplitude of the sine wave reference voltage. The width of the pulse
at the center of the half – cycle is maximum and decreases on either side. The figure 6(a) shows the
generation of the output signal by comparing a sinusoidal reference sign ....etc

[:=Read Full Message Here=:]

H-BRIDGE VSC WITH A T-CONNECTED TRANSFORMER BASED
THREE-PHASE FOUR-WIRE DSTATCOM FOR POWER QUALITY
IMPROVEMENT


I. INTRODUCTION


THE present day ac power distribution systems is
suffering from severe power quality problems. These
power quality problems include high reactive power
burden, harmonics currents, load unbalance, excessive
neutral current etc. . The power quality at the point
of common coupling (PCC) with the utility grid is
governe ....etc

[:=Read Full Message Here=:]

Abstract
This paper presents a general model of dual infeedHVDC system applying VSC-HVDC, which can be used as anelement in large multi infeed HVDC system. The model may havedifferent structure under different grid faults because of theaction of breakers. Hence power flow of the system based on thismodel is analyzed under steady state and different kinds of gridfault transient situations. Two main control methods applied onVSC-HVDC page link in this dual infeed HVDC system areinvestigated, and comparative analysis of them under transie ....etc

[:=Read Full Message Here=:]

MODELING AND APPLICATION OF VSC-HVDC IN THE
EUROPEAN TRANSMISSION SYSTEM


Abstract –

The present paper focuses on the technical,
environmental, and economic features of VSC-based
HVDC technologies. The aim is to investigate the impact of
VSC-HVDC on the European power system: specific attention
is paid to the transmission capacity enhancement
attainable in targeted applications. Towards this purpose,
an original steady state model of the VSC-HVDC is presented
and tested. Then, a techno-economic analysi ....etc

[:=Read Full Message Here=:]

sir i m BTECH,FINAL YEAR electrical engineering student from IET,LUCKNOW i m working with the pid control based single phase inverter design project so i m in need of simlink model of pwm inverter with steps for making my project so from your side i need your help .
pawan sharma ....etc

[:=Read Full Message Here=:]

Abstract:
The number of industry applications in which induction motors are fed by static frequency inverters is growing fast and, although much has already been done within this field, there is still a lot to be studied/understood regarding such applications. The advance of variable speed drives systems engineering increasingly leads to the need of specific technical guidance provision by electrical machines and drives manufacturers, In this paper we have studied and developed a simulink model with PWM inverter and find out the vario ....etc

[:=Read Full Message Here=:]

VSC-HVDC Control and Application in Meshed
AC Networks


Abstract

VSC-HVDC is a fully controllable transmission
device, allowing rapid and independent control of active power
transmitted over the dc page link and reactive power at each end of
the dc link. Embedding VSC-HVDC in meshed ac networks
opens up new possibilities to improve power grid reliability and
efficiency.

INTRODUCTION

SC-HVDC is a transmission technology based on voltage
source converters (VSC) and insulated gate bipolar
....etc

[:=Read Full Message Here=:]

I need IPFC SIMULINK model. just simulink file. please help me providing that file. mail to me at [email protected] ....etc

[:=Read Full Message Here=:]

pleae send me the reduction of harmonics in power systems or power quality improvement by wavelet transformation in matlab simulink.. ....etc

[:=Read Full Message Here=:]