hello can u send more details abt dis topic ....etc

[:=Read Full Message Here=:]

Respected sir,
please send the ppt and report in this paper for my project.




thank u ....etc

[:=Read Full Message Here=:]

An automotive AM/FM hidden antenna using the slot between the body of the automobile and a metal solar heat-reduction film in the front windshield is described. Such solar heat-reduction metal films are becoming common and thus represent an opportunity to incorporate an antenna at only marginal cost. The radio frequency (RF) input impedance and gain patterns are described, and techniques for impedance matching are shown. ,Theoretical and experimental antenna patterns are compared in this seminars,The application of this mobile system to the me ....etc

[:=Read Full Message Here=:]

SLOT VIEW SIMULATION OF WIND ELECTRICAL SYSTEMS



ABSTRACT
As a result of increasing environmental concern, more and more electricity is generated from renewable sources. One way of generating electricity from renewable sources is to use wind turbines. A tendency to erect more and more wind turbines can be observed. As a result of this, in the near future wind turbines may start to influence the behaviour of electrical power systems. Therefore, adequate model ....etc

[:=Read Full Message Here=:]

TO DESIGN & FABRICATE A SIX SLOT GENEVA WHEEL MECHANISM
INTRODUCTION
The Geneva mechanism is a timing device. It is used in many counting instruments and in other applications where an intermittent rotary motion is required. Essentially, the Geneva mechanism consists of a rotating disk with a pin and another rotating disk with slots (usually six) into which the pin slides. The Geneva mechanism was originally invented by a watch maker. The watch maker only put a limited number of slots in one of the rotating disks ....etc

[:=Read Full Message Here=:]

INTRODUCTION
LARGE generators play a key role in power systems. Because they are expensive, unexpected breakdowns represent huge economic losses. High quality maintenance is therefore essential to ensure a high level of availability. In short, it is very important to ensure that large generators are in good repair and can run stably The vibration of stator bars caused by electromagnetic force exists in the operation of large generators and this is worsened by loose stator slot wedges. The severe vibration accel ....etc

[:=Read Full Message Here=:]

Torque Ripple Minimization in a Switched
Reluctance Drive by Neuro-fuzzy
Compensation

Simple power electronic drive circuit and fault tolerance of converter are specific advantages of SRM drives, but excessive torque ripple has limited its use to special applications. A new method for shaping the motor currents so that the ripple can be reduced is presented by this paper. Here, a compensating signal is added to the output of a PI
controller. This i ....etc

[:=Read Full Message Here=:]

Torque Ripple Minimization Of Switched Reluctance Machine
Using Genetic Algorithm

A major problem of Switched Reluctance Motors (SRM) is the Torque ripple, which causes undesirable acoustic noise and vibration. saliency of the stator and rotor is the main cause for this. This article describes an algorithm for reducing the torque dip on the basis of Genetic Algorithm (GA), thereby reducing the associated torque ripple.

Introduction
because of its simple mechanical structure and development ....etc

[:=Read Full Message Here=:]

Ripple-Carry Addition


Four-Bit Ripple-Carry Adder
• Four full adders connected in a ripple-carry chain form a four-bit
ripple-carry adder. ....etc

[:=Read Full Message Here=:]

hello can u send me d infomation abt dis topic pls send me as soon as possible ....etc

[:=Read Full Message Here=:]