STEPLESS SPEED DRIVES &CONTINUOUSLY VARIABLE TRANSMISSION (CVT)
INTRODUCTION
A continuously variable transmission (CVT) is a transmission that can change steplessly through an infinite number of effective gear ratios between maximum and minimum values.
This contrasts with other mechanical transmissions that offer a fixed number of gear ratios.
The flexibility of a CVT allows the driving shaft to maintain a constant angular velocity over a range of output velocities.
ADVANTAGES
This can provide better ef ....etc

[:=Read Full Message Here=:]

I need it for my assignment we have got . General topic is drives
....etc

[:=Read Full Message Here=:]

TYPES OF BELT DRIVES AND THEIR POWER TRANSMISSION CAPACITY ....etc

[:=Read Full Message Here=:]

difference between chopper fed drives and converter fed drives pdf ....etc

[:=Read Full Message Here=:]

I need design calculations for 2 mm dia rope drive to lift load of 500N ....etc

[:=Read Full Message Here=:]

From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives: influence
Abstract —
Serpentine belt drives are often used in front
end accessory drive of automotive engine. The accessories
resistant torques are getting higher within new technological
innovations as stater-alternator, and belt transmissions
are always asked for higher capacity. Two kind of tensioners
are used to maintain minimum tension that insure power
transmission and minimize slip: dry friction or hydraulic
tensioners. An ....etc

[:=Read Full Message Here=:]

CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS
INTRODUCTION TO DRIVES

Mechanical components used for power transmission.It may be belt, chain or gear depending on engine design parameters like - Distance between crankshaft and camshaft, engine maximum speed, engine-torque and engine construction cost.- Power transmission is done from one shaft to another shaft which may or may not rotate at same spe ....etc

[:=Read Full Message Here=:]

Introduction and dascribe this topic around 20 slider ....etc

[:=Read Full Message Here=:]

hello,i dig your web site while searching for polaris gearing calculator about atv,it is for a scrambler 400 1999 full build with heavy mods,
i work and fine tune those thing for 20 years,here is my question:through the years i've tried many,many gearing combo,since the first stock set til now with new smaller tires.
i use the 2001 2x4 tranny for my scrammy,i want to put best power to the rear wheels using the stock clutchs (only parts differents are aftermarket like,weights,springs,helix...)the 01 tranny doesn't have the same gear ratio insi ....etc

[:=Read Full Message Here=:]

Introduction to Belt drives



Typical belt drives

Two types of belt drives, an open belt drive, (Fig. 13.1.1) and a crossed belt drive (Fig. 13.1.2) are shown. In both the drives, a belt is wrapped around the pulleys. Let us consider the smaller pulley to be the driving pulley. This pulley will transmit motion to the belt and the motion of the belt in turn will give a rotation to the larger driven pulley. In open belt drive system the rotation of both the pulleys is in the same direction, whereas, for cross ....etc

[:=Read Full Message Here=:]