I need it for my assignment we have got . General topic is drives
....etc

[:=Read Full Message Here=:]

Prepared by:
MUHAMMAD NASIRUDDIN MAHYUDDIN


Introduction

The first step is to determine tha control. The purpose of the control law is to allow us to assign a set of pole locations for the closed-loop system that will correspond to satisfactory dynamic response in terms of rise time and other measure of transient response.
Then, secondly, we show how to introduce the reference input with full-state feedback. We describe the process of finding the poles for good design. In the second step, If t ....etc

[:=Read Full Message Here=:]

hello,i dig your web site while searching for polaris gearing calculator about atv,it is for a scrambler 400 1999 full build with heavy mods,
i work and fine tune those thing for 20 years,here is my question:through the years i've tried many,many gearing combo,since the first stock set til now with new smaller tires.
i use the 2001 2x4 tranny for my scrammy,i want to put best power to the rear wheels using the stock clutchs (only parts differents are aftermarket like,weights,springs,helix...)the 01 tranny doesn't have the same gear ratio insi ....etc

[:=Read Full Message Here=:]

pls send me the ppt on the above mentioned topic by tomorrow evening.. its urgent pls.. ....etc

[:=Read Full Message Here=:]

Abstract

A belt is a looped strip of flexible material, used to mechanically page link two or more rotating shafts.
They may be used as a source of motion, to efficiently transmit power, or to track relative movement. Belts are looped over pulleys.
In a two pulley system, the belt can either drive the pulleys in the same direction, or the belt may be crossed, so that the direction of the shafts is opposite.

For more information, please visit
http://srmuniv.acdownloads/belt_drive.ppt
....etc

[:=Read Full Message Here=:]

i wnt immediately a ppt on ultrasonic spectacles and waist belt for visually impaired and blind persons
....etc

[:=Read Full Message Here=:]

Difference between the chopper fed and converter fed drives ....etc

[:=Read Full Message Here=:]

please do send me the ppt of the project(pendrive to pendrive data transfer without using pc)
....etc

[:=Read Full Message Here=:]

sir
i am final year stdnt want detail of ckt diag and costof projkt.
also plz sent your official adds so ican contact u.
thanks sachin
emsil [email protected] ....etc

[:=Read Full Message Here=:]

From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives: influence
Abstract —
Serpentine belt drives are often used in front
end accessory drive of automotive engine. The accessories
resistant torques are getting higher within new technological
innovations as stater-alternator, and belt transmissions
are always asked for higher capacity. Two kind of tensioners
are used to maintain minimum tension that insure power
transmission and minimize slip: dry friction or hydraulic
tensioners. An ....etc

[:=Read Full Message Here=:]