We analyze the feedback loop in Tele-Graffiti, a cameraprojectorbased remote sketching system which we recentlydeveloped. We derive the gain through the feedback loopand the final images that will be viewed by the users of thesystem. We then derive the “optimal gain” as the gain thatresults in the final viewed images being as close as possibleto the sum of the images actually drawn on the paper. Wealso propose a way of using the projector to compensate forinsufficient ambient light and describe how our analysis isaffected by: (1) automat ....etc

[:=Read Full Message Here=:]

Hi, can anybody help me with the coding for early detection of cascading failure in power transmission system (steady state condition) using neural network ....etc

[:=Read Full Message Here=:]

Hi, can anybody help me with the coding for early detection of cascading failure in power transmission system (steady state condition) using neural network ....etc

[:=Read Full Message Here=:]

PRESENTED BY:
Heemanshu das






INTRODUCTION
With the rapid development of power system, especially the increased use of transmission facilities due to higher industrial output and deregulation, it becomes necessary to explore new ways of maximizing power transfer in existing transmission facilities, while at the same time maintaining the acceptable levels of the network reliability and stability. On the other hand, the fast development of power electronic technology has m ....etc

[:=Read Full Message Here=:]

WHY THE TRANSMISSION LINE SET FOR 750KM? ....etc

[:=Read Full Message Here=:]

Abstract
In this paper steady-state modeling of Static VAR Compensator (SVC) and Thyristor Controlled Series Compensator (TCSC) for power flow studies has been represented and discussed in details. Firing angle model for SVC was proposed to control the voltage at which it is connected. In same manner firing angle model for TCSC is used to control active power flow of the line to which TCSC is installed. The proposed models take firing angle as state variable in power flow formulation. To validate the effectiveness of the proposed mode ....etc

[:=Read Full Message Here=:]

Hi there,
I need help with this topic. Does anyone know how to implement this with Matlab. ....etc

[:=Read Full Message Here=:]

Hai...........
Im Jeya Sudha.K,pursuing my Masters in Engineering in Sethu Institute of Technology,virudhunagar,TamilNadu,India...My domain is Power Electronics & Drives.....Im looking for the project papers related to my stream.....and i wanna the complete paper of the topic Design modeling & simulation of SVC for 750km (?/8) transmission line..If it is available just mail me.Also i welcome any other project paper related to my stream.But i want the complete IEEE base paper......


Warm wishes and regards
K.Jeya Sudha M.E
[/font ....etc

[:=Read Full Message Here=:]

Modeling and Control Coordination of
Power Systems with FACTS Devices in
Steady-State Operating Mode


by

Van Liem NGUYEN
This thesis is presented for the degree of Doctor of Philosophy
of The University of Western Australia
Energy Systems Centre
School of Electrical, Electronic and Computer Engineering



ABSTRACT



This thesis is devoted to the development of new models for a recently-implemented
FACTS (flex ....etc

[:=Read Full Message Here=:]

I Kodak.

I am want to find out, how does Static Var Compensator(SVC) employed to automatic control power quality and compensate for harmonic distortion problems.

I know a bit of basic operation reading SVC.

Current stage I have no clue, where to start and how.

Problem is drafting of conceptual design and control system regarding SVC and harmonic distortion.

I just want to find clue of the conceptual design for; adaption of SVC to control power quality and compensate for harmonic problems



....etc

[:=Read Full Message Here=:]