ABSTRACT
Now a day’s everything is depending up on the power. So give the reliable supply to the consumers. In distribution systems one of the major parts is SUBSTATIONS.
An electrical substation is a subsidiary station of an electricity, Generation, Transmission and distribution systems where the voltage is transformed from high to low or reverse using the transformers .Electric power may flow through several substations between generating plant and consumer and may be changed in different voltage levels .t ....etc

[:=Read Full Message Here=:]

Presented by :-
Ganesh Prasad


What is Opto-electronics .:-
It the branch of electronics dealing with devices that generate, transform, transmit, or sense optical, infrared, or ultraviolet radiation, as solar cells and lasers.
Component of opto-electronics. :-
What is Opto-electronics Sensor.:-
An opto-electronic sensor is a device that is capable of producing an electrical signal that is proportional to the amount of light incident on the active area of the device.
Integrated optoelectro ....etc

[:=Read Full Message Here=:]

ABSTRACT:
When we think about warehouses of today’s industries, the first thought that pops is “THE DARKNESS”. This paper deals with the automatic switching ON and OFF of lights in warehouses using micro processors and sensors. The circuit consists of two optical sensors, counters, phototransistors and relay switches. One optical sensor is installed at the entry door and another optical sensor is installed at the exit door of the ware house. The receiver sections of the sensors ....etc

[:=Read Full Message Here=:]

Do you have an HFSS (V 13) tutorial on designing a coax ferrite circulator? ....etc

[:=Read Full Message Here=:]

A Project Report on
Simulation Testbed for Evaluation of
Critical Software in Launch Sequence
Submitted in Partial fulfillment of the requirements for the award of
the degree of
Master of Technology
In
Software Engineering
Submitted by
Sreebal I S
Under the Esteemed Guidance of
Mr. Santhosh Kumar G
Lecturer
Dept. of Computer Science, CUSAT
DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY,
KOCHI-682022, KERALA
JUNE 2008Page 2
Page 3

DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND ....etc

[:=Read Full Message Here=:]

project based on opto electronics sensors system for SYBCS..
electronics circuit diagram,used for electrical appliances,examples,ppt etc. ....etc

[:=Read Full Message Here=:]

Hello.
i need the step by step guideline for constructing the microwave isolator in HFSS software asap.
thanks ....etc

[:=Read Full Message Here=:]

CHAPTER 1
INTRODUCTION
1.1 INTRODUCTION:-
India is worldâ„¢s largest democracy. It is perceived to be charismatic one as it accommodates cultural, regional, economical, social disparities and still is able to stand on its own. Fundamental right to vote or simply voting in elections forms the basis of Indian democracy.
In India all earlier elections be it state elections or centre elections a voter used to cast his/her vote to his/her favorite candidate by putting the stamp against his/her name and then foldi ....etc

[:=Read Full Message Here=:]

OPERATIONAL AMPLIFIERS
OPERATIONAL AMPLIFIERS (OP-AMP)
The standard operational amplifier (op-amp) symbol is shown in Figure 12-1(a). It has two terminals, the inverting input
(-) and the non inverting input (+), and one output terminal. The typical op-amp operates with two dc supply voltages, one positive and the other negative, as shown in Figure 12-1(b). Usually these dc voltage terminals are left off the schematic symbol for simplicity but are always understood to be there.
The Ideal Op-Amp
The ideal op-a ....etc

[:=Read Full Message Here=:]

Abstract


A multidisciplinary team of end users and suppliers has collaborated to develop a novel yet broadly enabling process for the design, fabrication and assembly of Micro-Opto-Electro-Mechanical Systems (MOEMS). A key goal is to overcome the shortcomings of the polysilicon layer used for fabricating optical components in a conventional surface micromachining process. These shortcomings include the controllability and uniformity of material stress that is a major cause of curvature and deformation in released microstructures. The appr ....etc

[:=Read Full Message Here=:]

Submitted by
ALVASIM P. A.
ANUMOL R.
GEO JOY
NIMMY YESUDAS
PRADEEP K. VIJAYAN

MET’S SCHOOL OF ENGINEERING
MALA, THRISSUR DISTRICT

ABSTRACT

Remote controlled Fan Regulator is one of the applications of electronics to increase the facilities of life. Fan is one of the unavoidable Electronic equipment in our day today life. It has become essential element without which people can’t lead a smooth life. The presence of a fan in ....etc

[:=Read Full Message Here=:]

A prototype of a fully electronic on-load semiconductor tap changer for power transformer has been
designed and built. With the emergence of high power semiconductor devices, problems associated with the mechanical on-load tap changer have been properly rectified. In this work, the prototype was constructed with triacs as the switching devices and microcontroller as the triggering circuit. The results obtained from this work show that the prototype has a faster time response of approximately 0.44s to react to any load chang ....etc

[:=Read Full Message Here=:]

This article is presented by:
M. R. Dutta Majumdar
Debasish Das
Tapan K. Nayak
Variable Energy Cyclotron Centre,
1/AF, Bidhan Nagar, Kolkata - 700064, INDIA

Opto-Electronics in Large Array Gas Detector Systems

ABSTRACT
Large array gas detector systems are used in particle and nuclear physics experiments involving high-energy nucleon-nucleon and heavy-ion collisions. We have observed that in large array gas detector systems the momentary discharges inside t ....etc

[:=Read Full Message Here=:]

Presented by :-
Ganesh Prasad


What is Opto-electronics .:-
It the branch of electronics dealing with devices that generate, transform, transmit, or sense optical, infrared, or ultraviolet radiation, as solar cells and lasers.
Component of opto-electronics. :-
What is Opto-electronics Sensor.:-
An opto-electronic sensor is a device that is capable of producing an electrical signal that is proportional to the amount of light incident on the active area of the device.
Integrated optoelectro ....etc

[:=Read Full Message Here=:]

Submitted by
ALVASIM P. A.
ANUMOL R.
GEO JOY
NIMMY YESUDAS
PRADEEP K. VIJAYAN

MET’S SCHOOL OF ENGINEERING
MALA, THRISSUR DISTRICT

ABSTRACT

Remote controlled Fan Regulator is one of the applications of electronics to increase the facilities of life. Fan is one of the unavoidable Electronic equipment in our day today life. It has become essential element without which people can’t lead a smooth life. The presence of a fan in ....etc

[:=Read Full Message Here=:]

Tool wear has long been identified as the most undesirable characteristic of the machining operations. Flank wear, is particular directly affects the work piece dimensions and the surface quality. A reliable and sensitive technique for monitoring the tool wears with out interrupting the process, is curtail in realization of the modern manufacturing concepts like unmanned machining centers, adaptive control optimization, etc. in this work an opto-electronic sensor is used in conjunction with a multilayered neural network for predicting the flan ....etc

[:=Read Full Message Here=:]

SCRAMJET
SEMINAR REPORT
BY
HARISHANKER
DEPARTMENT OF MECHANICAL ENGINEERING
LOURDES MATHA COLLEGE OF SCIENCE&TECHNOLOGY
KUTTICHAL, THIRUVANANTHAPURAM
NOVEMBER 2010




ABSTRACT

A scramjet (supersonic combustion ramjet) is reminiscent of a ramjet. The basic components of scramjet are inlet, diffuser, fuel injector, flame holder, igniter, and combustion chamber and exhaust nozzle. The basic principle of scramjet is same as that of any type of engine, intake, compression, combustion ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]