1. I want some idea about this subject ?
I want to choose this topic as a final project ?

2. I know the rough idea about this topic. I want some more information about this topic.

3. I am explaining the working of this project:
i. First the battery is charged with external current.
ii. with the help of battery the motor is run.
iii. The rotating shaft of motor is connected to the rear wheels.
Additional process
iv.The alternater is connected to rear shaft which is connected to rear wheels by chain or belt drive.
....etc

[:=Read Full Message Here=:]

This article is presented by:
M. R. Dutta Majumdar
Debasish Das
Tapan K. Nayak
Variable Energy Cyclotron Centre,
1/AF, Bidhan Nagar, Kolkata - 700064, INDIA

Opto-Electronics in Large Array Gas Detector Systems

ABSTRACT
Large array gas detector systems are used in particle and nuclear physics experiments involving high-energy nucleon-nucleon and heavy-ion collisions. We have observed that in large array gas detector systems the momentary discharges inside t ....etc

[:=Read Full Message Here=:]

project based on opto electronics sensors system for SYBCS..
electronics circuit diagram,used for electrical appliances,examples,ppt etc. ....etc

[:=Read Full Message Here=:]

BATTERY CHARGERS & BATTERY BANKS
INTRODUCTION
NEED OF BATTERY CHARGERS & BATTERY BANKS
Station battery charger is used to supply the control power to the electrical switchgear like breakers etc which need the DC supply for it’s operation and in case of failure of electrical power the control power is continued to be fed by the battery.
Battery Charger consists of
1) Float Charger
2) Boost Charger
Schemes for Battery Chargers
1) FC & FCBC scheme
2) FCBC & FCBC scheme
SINGLE LINE ....etc

[:=Read Full Message Here=:]

Tool wear has long been identified as the most undesirable characteristic of the machining operations. Flank wear, is particular directly affects the work piece dimensions and the surface quality. A reliable and sensitive technique for monitoring the tool wears with out interrupting the process, is curtail in realization of the modern manufacturing concepts like unmanned machining centers, adaptive control optimization, etc. in this work an opto-electronic sensor is used in conjunction with a multilayered neural network for predicting the flan ....etc

[:=Read Full Message Here=:]

Presented by :-
Ganesh Prasad


What is Opto-electronics .:-
It the branch of electronics dealing with devices that generate, transform, transmit, or sense optical, infrared, or ultraviolet radiation, as solar cells and lasers.
Component of opto-electronics. :-
What is Opto-electronics Sensor.:-
An opto-electronic sensor is a device that is capable of producing an electrical signal that is proportional to the amount of light incident on the active area of the device.
Integrated optoelectro ....etc

[:=Read Full Message Here=:]

hai my name is sreeram and i want the full report and power point clip of Zebra battery technologies for all electric smart car.i have the discription but i dont have report and clip . ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

working of conventional battery vs paper battery ....etc

[:=Read Full Message Here=:]

Abstract


A multidisciplinary team of end users and suppliers has collaborated to develop a novel yet broadly enabling process for the design, fabrication and assembly of Micro-Opto-Electro-Mechanical Systems (MOEMS). A key goal is to overcome the shortcomings of the polysilicon layer used for fabricating optical components in a conventional surface micromachining process. These shortcomings include the controllability and uniformity of material stress that is a major cause of curvature and deformation in released microstructures. The appr ....etc

[:=Read Full Message Here=:]