Hello sir,
i am giving seminar on the above IEEE Paper . I am sending u the abstract of my paper.


This research paper aims to develop an isolated-word automatic speech recognition (IWASR) system based on vector quantization (VQ). This system receives, analyzes, searches and matches an input speech signal with the trained set of speech signals which are stored in the database/codebook, and returns matching results to users. IWASR is meant to assist customers calling a universitypsilas telephone operator to respond to their enquiries in a ....etc

[:=Read Full Message Here=:]

Abstract
This paper deals with a new isolated wind–hydro
hybrid generation system employing one squirrel-cage induction
generator (SCIG) driven by a variable-speed wind turbine
and another SCIG driven by a constant-power hydro turbine
feeding three-phase four-wire local loads. The proposed system
utilizes two back-to-back-connected pulsewidth modulationcontrolled
insulated-gate-bipolar-transistor-based voltage-source
converters (VSCs) with a battery energy storage system at their
dc link. The main objectives of the control al ....etc

[:=Read Full Message Here=:]

Isolated word, speaker independent speech recognition

Project Goals

To make appliances smart
Use Dynamic Time Warping algorithm
13 Mel frequency Cepstral coefficients as the extracted features
Gui development and hardware interface


submitted by
Kaustubh R. Kale
Guide: Dr. John G. Harris



Description

Schematic Diagram
Endpoint detection in Java
DTW analysis in Matlab
Parallel Port operations via C++
Demo ....etc

[:=Read Full Message Here=:]

ABSTRACT
Speech and Audio processing techniques are used along with statistical pattern recognition principles to solve the problem of music instrument recognition. Non temporal, frame level features only are used so that the proposed system is scalable from the isolated notes to the solo instrumental phrases scenario without the need for temporal segmentation of solo music. Based on their effectiveness in speech, Line Spectral Frequencies(LSF) are proposed as features for music instrument recognition. The proposed system has also bee ....etc

[:=Read Full Message Here=:]

Introduction
The zero-cross family of optically isolated triac drivers is an inexpensive, simple and effective solution for interface applications between low current dc control circuits such as logic gates and microprocessors and ac power loads (120, 240 or 380 volt, single or 3-phase). These devices provide sufficient gate trigger current for high current, high voltage thyristors, while providing a guaranteed 7.5 kV dielectric withstand voltage between the line and the control circultry. An integrated, ze ....etc

[:=Read Full Message Here=:]

This article is presented by:

Yrd.Doç.Dr.Mutlu Boztepe


Transformer isolation

Objectives:
• Isolation of input and output ground connections, to meet
safety requirements
• Reduction of transformer size by incorporating high
frequency isolation transformer inside converter
• Minimization of current and voltage stresses when a
large step-up or step-down conversion ratio is needed —
use transformer turns ratio
• Obtain multiple output voltages via multiple transfo ....etc

[:=Read Full Message Here=:]

presented by:
PARIK GARG


STUDY OF UNIAXIALLY ASYMMETRIC SEISMICALLY ISOLATED RC BUILDING
Need for seismic isolation of a Structure
Increased building safety and post earthquake operability are desired.
Reduced lateral design forces are desired.
Alternate forms of construction with limited ductility capacity (such as pre-cast concrete) are desired in an earthquake region.
An existing structure is not currently safe for earthquake loads.
RB(Laminated Rubber Bearing)System
LRB Lead Rubber Bearing System ....etc

[:=Read Full Message Here=:]

Bridges are lifeline structures. They act, as an important page link in surface transportation network and failure of bridges during a seismic event will seriously hamper the relief and rehabilitation work. There are many cases of damage of bridges in the past earthquakes all over the world. Due to their structural simplicity, bridges are particularly vulnerable to damage and even collapse when subjected to earthquakes. The fundamental period of vibration of a majority of bridges is in the range of 0.2 to 1.2 second. In this range, the structur ....etc

[:=Read Full Message Here=:]

Bridges are lifeline structures. They act, as an important page link in surface transportation network and failure of bridges during a seismic event will seriously hamper the relief and rehabilitation work. There are many cases of damage of bridges in the past earthquakes all over the world. Due to their structural simplicity, bridges are particularly vulnerable to damage and even collapse when subjected to earthquakes. The fundamental period of vibration of a majority of bridges is in the range of 0.2 to 1.2 second. In this range, the structur ....etc

[:=Read Full Message Here=:]

can i get a readymade plagerizm report for my topic ....etc

[:=Read Full Message Here=:]