Introduction

The Universal Asynchronous Receiver Transmitter (UART) is the most widely used serial data communication circuit ever. UARTs allow full duplex communication over serial communication links as RS232. UARTs are available as inexpensive standard products from many semiconductor suppliers, making it unlikely that this specific design is useful by itself.

The basic functions of a UART are a microprocessor interface, double buffering of transmitter data, frame generation, parity generation, parallel to serial conversion, double buf ....etc

[:=Read Full Message Here=:]

Accurate Modeling of Optical Multiplexer/Demultiplexer Concatenation
in Transparent Multiwavelength Optical Networks



I. INTRODUCTION
IN TRANSPARENT multiwavelength optical networks,
each lightwave signal may be optically multiplexed/demultiplexed
several times during propagation from its source
to its destination . Optical multiplexers/demultiplexers
(MUXs/DMUXs) exhibit nonideal amplitude and phase
transfer functions within the optical signal band ....etc

[:=Read Full Message Here=:]

Definition
These computers include the entire spectrum of PCs, through professional workstations up to super-computers. As the performance of computers has increased, so too has the demand for communication between all systems for exchanging data, or between central servers and the associated host computer system.The replacement of copper with fiber and the advancement sin digital communication and encoding are at the heart of several developments that will change the communication infrastructure. The former development has provided us with hu ....etc

[:=Read Full Message Here=:]

Abstract
This paper proposes a novel adaptive pseudo-carry compensation truncation (PCT) scheme, which is derived for the multiplexer basedarray multiplier. The proposed method yields low average error among existingtruncation methods. The new PCT based truncated array multiplieroutperforms other existing truncated array multipliers by as much as 25%in terms of silicon area and delay, and consumes about 40% less dynamicpower than the full-width multiplier for 32-bit operation. The proposedtruncation scheme is applied to an image compres ....etc

[:=Read Full Message Here=:]

Definition

Computer chips of today are synchronous. They contain a main clock, which controls the timing of the entire chips. There are problems, however, involved with these clocked designs that are common today.One problem is speed. A chip can only work as fast as its slowest component. Therefore, if one part of the chip is especially slow, the other parts of the chip are forced to sit idle. This wasted computed time is obviously detrimental to the speed of the chip.

New problems with speeding up a clocked chip are just around the corn ....etc

[:=Read Full Message Here=:]

Universal Asynchronous Receiver Transmitter (UART)

The Universal Asynchronous Receiver Transmitter (UART) is the most widely used serial data communication circuit ever. UARTs allow full duplex communication over serial communication links as RS232. UARTs are available as inexpensive standard products from many semiconductor suppliers, making it unlikely that this specific design is useful by itself.

The basic functions of a UART are a microprocessor interface, double buffering of transmitter d ....etc

[:=Read Full Message Here=:]

PRESENTED BY :
VINUPRASAD O M


ADD-ON MULTIPLEXER IN WIRE COMMUNICATION SYSTEM AND A COMPARITIVE STUDY WITH OLD TECHNIQUE
AN OVER-VIEW……..
 Conventional wire communication.
 What’s an ADD-ON multiplexer.
 Basic difference between Conventional and add-on multiplexer using wire communication.
 A comparative study.
 Basic principle and working.
 Positive results.
 Further improvements…..
• Conventional Wire-Communication :
Our Point of ....etc

[:=Read Full Message Here=:]

Introduction

The Universal Asynchronous Receiver Transmitter (UART) is the most widely used serial data communication circuit ever. UARTs allow full duplex communication over serial communication links as RS232. UARTs are available as inexpensive standard products from many semiconductor suppliers, making it unlikely that this specific design is useful by itself.

The basic functions of a UART are a microprocessor interface, double buffering of transmitter data, frame generation, parity generation, parallel to serial conversion, double buf ....etc

[:=Read Full Message Here=:]

HAI HOW ARE U CAN U GIVE ME A MINI PROJECTS IDEA ON MULTIPLEXERS I NEED IT TO SUBMIT MY PROJECT ON OR BEFORE THIS MONDAY SO PLEASE HELP ME TO GIVE A NICE,EXCELENT PROJECT ....etc

[:=Read Full Message Here=:]

1. INTRODUCTION

Computer chips of today are synchronous. They contain a main clock, which controls the timing of the entire chips. There are problems, however, involved with these clocked designs that are common today.

One problem is speed. A chip can only work as fast as its slowest component. Therefore, if one part of the chip is especially slow, the other parts of the chip are forced to sit idle. This wasted computed time is obviously detrimental to the speed of the chip.

New problems with speeding up a clo ....etc

[:=Read Full Message Here=:]