Hi...
Im urgently in need of seminar topics of related turbomachinery .... So i selected these topics which are placed topics in this site. If u people hav anymore related topics to turbomachinery please send it to me..:-/ ....etc

[:=Read Full Message Here=:]

ial] ....etc

[:=Read Full Message Here=:]

Hydro Drive is a drive or transmission system that uses hydraulic fluid under pressure to drive machinery. The term hydrostatic refers to the transfer of energy from flow and pressure, not from the kinetic energy of the flow.consists mainly of three parts. The generator (e.g. a hydraulic pump, driven by an electric motor, a combustion engine or a windmill); valves, filters, piping etc. (to guide and control the system); the motor (e.g. a hydraulic motor or hydraulic cylinder) to drive the machinery ....etc

[:=Read Full Message Here=:]

please do send me the ppt of the project(pendrive to pendrive data transfer without using pc)
....etc

[:=Read Full Message Here=:]

Definition

Hydro Forming uses water pressure to form complex shapes from sheet or tube material. The pressure may go up about 60,000 psi depending on the component.

As the automobile industry strives to make car lighter, stronger and more fuel efficient, it will continue to drive hydro forming applications. Some automobile parts such as structural chassis, instrument panel beam, engine cradles and radiator closures are becoming standard hydro formed parts.

The capability of hydro forming can be more fully used to create complicated par ....etc

[:=Read Full Message Here=:]

Abstract

A belt is a looped strip of flexible material, used to mechanically page link two or more rotating shafts.
They may be used as a source of motion, to efficiently transmit power, or to track relative movement. Belts are looped over pulleys.
In a two pulley system, the belt can either drive the pulleys in the same direction, or the belt may be crossed, so that the direction of the shafts is opposite.

For more information, please visit
http://srmuniv.acdownloads/belt_drive.ppt
....etc

[:=Read Full Message Here=:]

During the last 12 years, general awareness of hydro forming has grown steadily . Although interest in hydroforming is wide ranging , the vast majority of application are in automobile industry .
Hydro forming is the process by which water pressure is used to form complex shapes from sheet or tube material.Applications of hydro forming in automotive industry are gaining globally in popularity. The trend in auto manufacturing of making parts lighter and more complicated with necessary strength reinforcement only where required is ....etc

[:=Read Full Message Here=:]

Prepared by:
MUHAMMAD NASIRUDDIN MAHYUDDIN


Introduction

The first step is to determine tha control. The purpose of the control law is to allow us to assign a set of pole locations for the closed-loop system that will correspond to satisfactory dynamic response in terms of rise time and other measure of transient response.
Then, secondly, we show how to introduce the reference input with full-state feedback. We describe the process of finding the poles for good design. In the second step, If t ....etc

[:=Read Full Message Here=:]

Hydro Drive

Hydro Forming uses water pressure to form complex shapes from sheet or tube material. The pressure may go up about 60,000 psi depending on the component.

As the automobile industry strives to make car lighter, stronger and more fuel efficient, it will continue to drive hydro forming applications. Some automobile parts such as structural chassis, instrument panel beam, engine cradles and radiator closures are becoming standard hydro formed parts.

The capability of hydro forming can ....etc

[:=Read Full Message Here=:]

Definition

Hydro Forming uses water pressure to form complex shapes from sheet or tube material. The pressure may go up about 60,000 psi depending on the component.

As the automobile industry strives to make car lighter, stronger and more fuel efficient, it will continue to drive hydro forming applications. Some automobile parts such as structural chassis, instrument panel beam, engine cradles and radiator closures are becoming standard hydro formed parts.

The capability of hydro forming can be more fully used to create complicated par ....etc

[:=Read Full Message Here=:]